Mercedes-Benz CLK430 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(40)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(40)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz CLK430 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2003 Mercedes-Benz CLK430V8-4.3LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2002 Mercedes-Benz CLK430V8-4.3LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2000 Mercedes-Benz CLK430V8-4.3LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
1999 Mercedes-Benz CLK430V8-4.3LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2001 Mercedes-Benz CLK430V8-4.3LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
Show example Mercedes-Benz CLK430 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(40)

Rating Summary
37
0
1
0
2
37
0
1
0
2

Jose

15 years of experience
213 reviews
Jose
15 years of experience
Mercedes-Benz CLK430 V8-4.3L - Serpentine/Drive Belt - Bradenton, Florida
Was able to do the job even with a speed bump in the process. On time and ready to get the job done.

Brandon

18 years of experience
318 reviews
Brandon
18 years of experience
Mercedes-Benz CLK430 V8-4.3L - Pre-purchase Car Inspection - Cary, North Carolina
Brandon was very helpful and detailed in the pre-purchase inspection. Definitely recommend him!

Jose

17 years of experience
154 reviews
Jose
17 years of experience
Mercedes-Benz CLK430 V8-4.3L - Radiator - Las Vegas, Nevada
Very happy with results and repair Jose arrived on time and completed work in a timely manner

Quentin

22 years of experience
213 reviews
Quentin
22 years of experience
Mercedes-Benz CLK430 V8-4.3L - Serpentine/Drive Belt - Houston, Texas
Great timing, great job done quick & professional.. will definitely use again and recommend

Excellent Rating

(40)

Rating Summary
37
0
1
0
2
37
0
1
0
2
Number of Mercedes-Benz CLK430 services completed
440+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Auxiliary Battery
If you have multiple batteries in your vehicle, you may have to replace one if the vehicle won't crank, fluid is leaking, or the Battery Light is on.
How Long Does a Throttle Controller Last?
In In order for your accelerator pedal to actually work as you push down on it, it needs to be connected to the throttle. In older model vehicles there was a mechanical link that connected the throttle body and the...
P0330 OBD-II Trouble Code: Knock Sensor 2 Circuit Malfunction (Bank 2)
P0330 code definition P0330 is a general OBD-II trouble code that is indicating a malfunction in the knock sensor circuit 2. Note:...

Transmission selector shaft seal leakage. Does it need to be fixed and how expensive is the repair?

If you are referring to the "manual shaft" seal pressed into a bore on the transmission case, which seal is typically around an inch in diameter, it is repairable (replaceable) on the car if there is physical access to the...

I don't know how to turn on my fog lights.

The fog light switch (https://i.ytimg.com/vi/77zyWjp4YPU/hqdefault.jpg) is on the left turn signal lever close to steering column the lever rotates to turn on the fog lights.

Engine jumps up in RPM when unnecessary.

Hi there. Typically when you rapidly accelerate while you're driving, the transmission will "down shift" into a lower gear to assist in the acceleration; which increases the engine RPM's until the transmission shifts into the higher gear. However, you shouldn't...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com