Mazda Protege5 Clean and Repack Wheel Bearing at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(71)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(71)

Clean and Repack Wheel Bearing Service

How much does a Clean and Repack Wheel Bearing cost?

On average, the cost for a Mazda Protege5 Clean and Repack Wheel Bearing is $152 with $0 for parts and $152 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2002 Mazda Protege5L4-2.0LService typeClean and Repack Wheel BearingEstimate$183.98Shop/Dealer Price$199.99 - $211.99
2003 Mazda Protege5L4-2.0LService typeClean and Repack Wheel BearingEstimate$151.98Shop/Dealer Price$168.01 - $180.04
Show example Mazda Protege5 Clean and Repack Wheel Bearing prices

What is cleaning and repacking the wheel bearings all about?

A car’s wheels rotate on tapered-roller bearings which fit between the stationary axle spindle and the rotating wheel’s hub/brake mechanism. There are bearings on the inner and outer side of the hub to properly support the wheel. These are greased when installed, but the grease can, and does, break down over time, allowing dry contact between the various elements. When left unattended, this will lead to wear and, ultimately, to bearing failure.

Keep in mind:

  • Since noise is the first symptom of metal-to-metal contact, it’s likely that damage has already occurred, and that bearing replacement may be necessary.
  • The job will require the removal of the wheel and brake assembly, so it might be advisable to inspect the brake pads, steering tie rods and suspension pieces in the process.
  • If you’re going to do one wheel, it’s only logical that you should also do the other side.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The front or rear wheels, brakes and hubs are removed from the vehicle
  • The front or rear wheel hubs, bearings are cleaned and greased then install a new grease seal in hub
  • The front or rear wheels, brakes and hubs are installed back on the vehicle
  • The vehicle is lowered off of the jack stands

Our recommendation:

Consider having this job done when your vehicle reaches high mileage, particularly if it has been operated with heavy loads or on unusually bumpy roads.

What is a common symptom indicating you need to clean and repack the wheel bearings?

  • Any noise noticeable from the wheels. It can start as a squeal, and then develop into a growl or even a grinding sound.

How important is this service?

A catastrophic wheel bearing failure can lead to the wheel coming off the car. Obviously, that could cause an accident or, at the very least, serious damage to the vehicle. It’s certainly worth discussing with one of our mechanics.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mazda mechanics

Real customer reviews from Mazda owners like you.

Excellent Rating

(71)

Rating Summary
67
3
0
0
1
67
3
0
0
1

Theodore

16 years of experience
1601 reviews
Theodore
16 years of experience
Mazda Protege5 L4-2.0L - Alternator - Sammamish, Washington
Very attentive and knowledgeable. He's fast and communicates well. Offered different options for our particular case.

James

12 years of experience
233 reviews
James
12 years of experience
Mazda Protege5 L4-2.0L - Car is not starting - Millbrae, California

Ejnar

29 years of experience
107 reviews
Ejnar
29 years of experience
Mazda Protege5 L4-2.0L - Clutch Slave Cylinder - San Jose, California
EJ was very patient, I hung around and he explained how the dysfunctional parts were effecting the clutch of my car. Before beginning the removal of my old clutch master/slave cylinders he performed a diagnostic to ensure that the service I booked was what my car needed. EJ has very good bedside manner and was genuinely a nice person to be around. Once again a great experience with Your Mechanic, I will continue to use the web site and service for future repairs.

Isai

27 years of experience
230 reviews
Isai
27 years of experience
Mazda Protege5 L4-2.0L - Engine or Transmission Mount Replacement - San Antonio, Texas
Having the 1st mechanic stand me up I was apprehensive on the outcome of the second scheduled apt. I've had my faith restored in this program thanks to Isai who showed up early ready to do the job which was done in my driveway for over have the price quoted from pep boys and the convenience is what sold me also. He discovered that the original bid from pep boys stated I needed 4 motor mounts and Isai was forthright telling me only two needed to be replaced. An honest mechanic is a rare commodity these days so Isai is who I will be requesting from here on out for all my vehicles needs.

Excellent Rating

(71)

Rating Summary
67
3
0
0
1
67
3
0
0
1
Number of Mazda Protege5 services completed
781+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mazda MECHANICS
1100+
experts on our platform

Recent articles & questions

P2646 OBD-II Trouble Code: 'A' Rocker Arm Actuator System Performance / Stuck Off Bank 1
P2646 code definition 'A' Rocker Arm Actuator System Performance or Stuck Off Bank 1 What the P2646 code means P2646 is an...
How to Recognize Brake Pad Wear Patterns
Brake pads apply pressure to the brake rotor to slow or stop a car. Brake pads that are wearing unevenly indicate that your brakes need adjustment.
How to Use Car Jacks and Jack Stands
Car jacks and jack stands raise a car so car tires can be changed or hard to reach parts of the car can be accessed for maintenance.

Loss of antifreeze at air intake

A common failure in your engine is the intake manifold and intake plenum gaskets. When this happens coolant will leak under where the throttle body is located. I would recommend having a certified mechanic, such as one from YourMechanic, inspect...

Opinion on Subaru Impreza symmetrical all-wheel system

It's a very interesting system and generally it works quite well. But, for the rest of the car--Subarus are notorious for blowing head gaskets and if they have automatic transmission, automatic transmissions are known for wearing out. So if you...

Hi Jerel, how are you? I have a 2008 chrysler sebring convertible and my check engine light is on, I went and had it checked and s

If you are referring to Codes P2004, P2017, and related codes (https://www.yourmechanic.com/article/p2004-obd-ii-trouble-code-intake-manifold-runner-control-stuck-open-bank-1-by-jamahl-walker), if those codes have set it means that the intake manifold runner control (IMRC) is stuck or sticking. The Powertrain Control Module (PCM) provides the IMRC with information...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com