Land Rover LR2 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(98)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(98)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Land Rover LR2 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2008 Land Rover LR2L6-3.2LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2012 Land Rover LR2L6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2014 Land Rover LR2L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2010 Land Rover LR2L6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2013 Land Rover LR2L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2011 Land Rover LR2L6-3.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2009 Land Rover LR2L6-3.2LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.28 - $130.25
2015 Land Rover LR2L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.94 - $131.39
Show example Land Rover LR2 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Land Rover mechanics

Real customer reviews from Land Rover owners like you.

Excellent Rating

(98)

Rating Summary
91
7
0
0
0
91
7
0
0
0

Charles

4 years of experience
116 reviews
Charles
4 years of experience
Land Rover LR2 L6-3.2L - Car Starter Repair - Hendersonville, Tennessee
Charles did an awesome job! Got here early and got me fixed right up! Very happy with the service!

Chris

16 years of experience
419 reviews
Chris
16 years of experience
Land Rover LR2 L6-3.2L - Brake Rotor/Disc Replacement (Rear) - South San Francisco, California
Chris showed on time and completed the rear brake job very quickly.

Wesley

13 years of experience
53 reviews
Wesley
13 years of experience
Land Rover LR2 L6-3.2L - Oil Change - San Antonio, Texas
Wesley was very friendly and knowledged in mechanics. Highly recommend Wesley and your mechanic - what a great idea and time saver for the customer! Prices are a little high but the concept is great!

Luis

18 years of experience
321 reviews
Luis
18 years of experience
Land Rover LR2 L4-2.0L Turbo - Brake Pads Replacement (Front) - East Brunswick, New Jersey
Luis’s is very experienced mechanic and very efficient too.

Excellent Rating

(98)

Rating Summary
91
7
0
0
0
91
7
0
0
0
Number of Land Rover LR2 services completed
1078+
services done by our mechanics
TOTAL NUMBER OF EXPERT Land Rover MECHANICS
500+
experts on our platform

Recent articles & questions

P0073 OBD-II Trouble Code: Ambient Air Temperature Sensor Circuit High input
P0073 code definition Ambient Air Temperature Sensor Circuit High input Depending on the type of vehicle these are some related OBD-II Diagnostic...
P0300 OBD-II Trouble Code: Random/Multiple Cylinder Misfire Detected
P0300 code definition Random/multiple cylinder misfire detected What the P0300 code means Most vehicles will have 4-6 cylinders. Each cylinder will fire...
P2084 OBD-II Trouble Code: Exhaust Gas Temperature (EGT) Sensor Circuit Range/Performance Bank 1 Sensor 2
Diagnostic Diagnostic Trouble Code (DTC): P2084 P2084 code definition Exhaust Gas Temperature (EGT) Sensor Circuit Range/Performance Bank 1 Sensor 2 Related Trouble Codes: P2080: EGT Sensor Circuit Range/Perf Bank 1 Sensor 1 P2081: EGT Sensor Circuit Intermittent Bank 1 Sensor...

Red lined engine by accident and now the engine idle is higher than normal. Smell something burning like rubber.

Hi there. The engine revving up higher than normal could be caused by the idle air control valve (IAC). The valve could have gotten stuck when the engine was throttled rapidly when first started. Check the IAC and see if...

My car is sliding to the side, when i brake

The abs light on (https://www.yourmechanic.com/services/abs-light-is-on-inspection) indicates there is a fault in the electronics of the anti-lock braking system. The car is most likely sliding sideways because a wheel, or wheels, are locking up - basically functioning as brakes not equipped...

My door handle came off. Everything seems intact. I guess it just came loose. Am I able to book an appointment to have it reinstalled?

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com