Jeep Comanche Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Jeep Comanche Car Battery Replacement is $295 with $155 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1992 Jeep ComancheL4-2.5L	Service typeCar Battery Replacement	Estimate$464.38	Shop/Dealer Price$545.33 - $780.06
1991 Jeep ComancheL6-4.0L	Service typeCar Battery Replacement	Estimate$455.37	Shop/Dealer Price$534.55 - $767.96
1990 Jeep ComancheL4-2.5L	Service typeCar Battery Replacement	Estimate$455.37	Shop/Dealer Price$534.57 - $768.00
1991 Jeep ComancheL4-2.5L	Service typeCar Battery Replacement	Estimate$455.37	Shop/Dealer Price$534.57 - $768.00
1990 Jeep ComancheL6-4.0L	Service typeCar Battery Replacement	Estimate$455.37	Shop/Dealer Price$536.05 - $770.58
1992 Jeep ComancheL6-4.0L	Service typeCar Battery Replacement	Estimate$455.37	Shop/Dealer Price$534.71 - $768.25

Show example Jeep Comanche Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Jeep mechanics

Real customer reviews from Jeep owners like you.

Excellent Rating

(9)

Rating Summary

8

0

0

0

1

8

0

0

0

1

SEE REVIEWS NEAR ME

Cesar

10 years of experience

292 reviews

Cesar

10 years of experience

by Rachel

Jeep Comanche L6-4.0L - Alternator - Marysville, Washington

Cesar is an excellent mechanic! Replaced both my alternator and starter in about an hour.

Cesar

10 years of experience

292 reviews

Cesar

10 years of experience

by Daniel

Jeep Comanche L6-4.0L - Car is not starting - Marysville, Washington

the best experience got me up an running in no time!

Henry

35 years of experience

177 reviews

Henry

35 years of experience

by Harold

Jeep Comanche L4-2.5L - Clear fluid is leaking - Blackwood, New Jersey

Prompt. Diagnosed the problem. Explained the solution clearly.

Horus

12 years of experience

122 reviews

Horus

12 years of experience

by daniel

Jeep Comanche L6-4.0L - Car is making a noise - San Antonio, Texas

he is great.

Excellent Rating

(9)

Rating Summary

8

0

0

0

1

8

0

0

0

1

SEE REVIEWS NEAR ME

Recent articles & questions

How to Replace a Throttle Controller

The throttle controller uses data to open and close the throttle. Common signs of failure include poor performance, stalling, and and rough idling.

P0635 OBD-II Trouble Code: Power Steering Control Circuit

P0635 means there's a problem with the power steering control circuit, often due to a faulty steering position, pressure switch, or broken wiring.

A Buyer’s Guide to the 2012 Nissan LEAF

The The introduction of the LEAF represented the beginning of an age many car experts were skeptical would even happen – true mass production of a 100% electric vehicle. Not only did it happen but the LEAF was grabbed up...

Engine misfiring 2003 Honda CR-V

Misfires (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-misfiring-engine) can be caused by several things. I would first check for vacuum leaks (https://www.yourmechanic.com/article/is-it-safe-to-drive-with-a-vacuum-leak), then I would pull the plugs to see if they need replacing. It is possible that have a fuel system concern, but I would...

transmission not shifting and the rpm's keep climbing up.

Hi there. It seems that the gears are slipping and causing the rpm's to climb up. Check the transmission fluid and make sure that it's full and red in color. Very dark red or black transmission fluid is an indication...

Engine and Transmission mounts have collapsed. Do they have to be replaced immediately? How much for both? TBC....

If the engine mounts are faulty, the drive axles will operate at the wrong angle eventually causing premature wear-out of the axles so it is important to get the mounts replaced. If you would please refer to YourMechanic's motor mount...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com