Infiniti G37 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(416)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(416)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Infiniti G37 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2008 Infiniti G37V6-3.7LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2012 Infiniti G37V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2010 Infiniti G37V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2011 Infiniti G37V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2013 Infiniti G37V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2009 Infiniti G37V6-3.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example Infiniti G37 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Infiniti mechanics

Real customer reviews from Infiniti owners like you.

Excellent Rating

(416)

Rating Summary
403
3
1
2
7
403
3
1
2
7

Pardeep

21 years of experience
1078 reviews
Pardeep
21 years of experience
Infiniti G37 V6-3.7L - Car starts and then dies - San Jose, California
Pardeep has provided an excellent service to my car, i was able to get my car up and running. He provided all the little details and was super helpful.

Manuel

12 years of experience
83 reviews
Manuel
12 years of experience
Infiniti G37 V6-3.7L - Alternator - Naples, Florida
very friendly, punctual and knowledgeable. He was very fast and efficient replacing my alternator,serpentine belt and brake caliper. Would definitely recommend Manuel for all your car needs.

Kenneth

20 years of experience
777 reviews
Kenneth
20 years of experience
Infiniti G37 V6-3.7L - Creaking noise when turning the steering wheel - Cerritos, California
kenneth is very professional . he was really knowledgeable and explains to in detail what is going on with your car

Shaun

16 years of experience
238 reviews
Shaun
16 years of experience
Infiniti G37 V6-3.7L - Brake System Flush - San Jose, California
Awesome. Professional.

Excellent Rating

(416)

Rating Summary
403
3
1
2
7
403
3
1
2
7
Number of Infiniti G37 services completed
4576+
services done by our mechanics
TOTAL NUMBER OF EXPERT Infiniti MECHANICS
900+
experts on our platform

Recent articles & questions

How Long Does a Power Steering Pressure Switch Last?
In In order to operate properly, your car’s power steering system needs to maintain the right amount of pressure at all times. The pressure control valve (also called a flow control valve) creates the pressure, but the system needs a...
How to Inspect Valve Clearance Adjustment
The The term “valve adjustment” is an oxymoron. What is actually being adjusted is the clearance between the linkage of the camshaft and the valve (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-valve-cover-gasket). It is most often called the valve lash. This system that links the camshaft...
How to Replace a Trunk Striker Plate
The trunk striker plates secures the lid when closed. It will need replacement if you hear rattling noises or see trunk warning lights on your dash.

The car accelerates slowly, hesitates and shudders

Unmetered air can cause this type of hesitation and shuddering. Too much air compared to fuel will cause a lean misfiring condition. Fault codes need to be read out of your Mercedes C320's engine computer to see if there are...

My Car will not crank regularly.

Hello there, many common faults will cause your 2011 Audi A4 to have issues starting. If you have to inset the key a number of times your vehicle may have an ignition issue, the most common are worn keys, ignition...

My belt and pulley fell off. What would cause this? Also, there is Green fluid leaking from front driver side.

The idler pulley or tensioner pulley may have seized up causing the pulley and belt to come off the engine. When these parts come off with the engine running, depending on how fast the engine was running (how high the...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com