Hummer H2 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(139)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(139)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Hummer H2 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2009 Hummer H2V8-6.2LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2005 Hummer H2V8-6.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2006 Hummer H2V8-6.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2004 Hummer H2V8-6.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2007 Hummer H2V8-6.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2003 Hummer H2V8-6.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2008 Hummer H2V8-6.2LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
Show example Hummer H2 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Hummer mechanics

Real customer reviews from Hummer owners like you.

Excellent Rating

(139)

Rating Summary
132
5
0
0
2
132
5
0
0
2

Ramon

7 years of experience
111 reviews
Ramon
7 years of experience
Hummer H2 V8-6.0L - Brake Master Cylinder - Los Angeles, California
Very nice and professional. Straight to the point. See you again. Thx

Jose

20 years of experience
69 reviews
Jose
20 years of experience
Hummer H2 V8-6.0L - Evaporative Emission Control Canister - Miami, Florida
very professional. And he really knows about cars!! Congrats!!!

Andrew

11 years of experience
845 reviews
Andrew
11 years of experience
Hummer H2 V8-6.2L - Car is not starting - Olathe, Kansas
Friendly on time and knew what he was doing.

Peter

43 years of experience
1321 reviews
Peter
43 years of experience
Hummer H2 V8-6.0L - Hydraulic Brake Booster - Scottsdale, Arizona
wonderful experience. On time, great work and fantastic at diagnostic.

Excellent Rating

(139)

Rating Summary
132
5
0
0
2
132
5
0
0
2
Number of Hummer H2 services completed
1529+
services done by our mechanics
TOTAL NUMBER OF EXPERT Hummer MECHANICS
200+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Chrysler Town & Country
While While the Chrysler Town & Country has been in production for over half a century, the 2012 Chrysler Town & Country is anything but old-fashioned. The model got a huge overhaul in 2011 and saw a few new upgrades...
How To Replace a Cabin Air Filter That’s Behind the Glove Box
Cabin Cabin air filters are a new feature found on many late model vehicles. These filters are responsible for filtering the air that enters the vehicle when the heating and air conditioning (AC) systems are in use. They prevent any...
P0445 OBD-II Trouble Code: Evaporative Emission Control System Purge Control Valve Circuit Shorted
Trouble code P0445 means the evaporative emission control system purge control valve has a problem.

Problem with intake manifold

Hi. This trouble code occurs in sync with a ticking noise within the circuit. If the manifold has lose bolts or was not put together correctly after maintenance this can be the result of the code. I would recommend having...

My front censors not working

Hi there. In order to give you some accurate ideas as to what is causing this problem we'd need to know your year, make and model of vehicle. However, if the issue has been previously diagnosed, and you're looking for...

2004 jeep liberty 3.7liter v6 sport

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com