GMC Sonoma Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(89)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(89)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a GMC Sonoma Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1991 GMC SonomaV6-4.3LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1993 GMC SonomaV6-2.8LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1998 GMC SonomaV6-4.3LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1994 GMC SonomaL4-2.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1996 GMC SonomaL4-2.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1994 GMC SonomaV6-4.3LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2002 GMC SonomaL4-2.2LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1991 GMC SonomaV6-2.8LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example GMC Sonoma Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert GMC mechanics

Real customer reviews from GMC owners like you.

Excellent Rating

(89)

Rating Summary
85
1
0
2
1
85
1
0
2
1

Eladio

10 years of experience
148 reviews
Eladio
10 years of experience
GMC Sonoma V6-4.3L - ignition coil pigtail - Winston Salem, North Carolina
Eladios was very knowledgeable, on time and friendly. He done a wonderful job

AL

12 years of experience
234 reviews
AL
12 years of experience
GMC Sonoma V6-4.3L - Car Radiator Replacement - Vancouver, Washington
Great

Jeffrey

27 years of experience
870 reviews
Jeffrey
27 years of experience
GMC Sonoma L4-2.2L - Other Inspections - Charlotte, North Carolina
Great guy very nice arrived early

Jason

17 years of experience
429 reviews
Jason
17 years of experience
GMC Sonoma V6-4.3L - Heater is not working - San Jose, California
Jason did aa great job

Excellent Rating

(89)

Rating Summary
85
1
0
2
1
85
1
0
2
1
Number of GMC Sonoma services completed
979+
services done by our mechanics
TOTAL NUMBER OF EXPERT GMC MECHANICS
900+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing AC Control Module
Common signs include inconsistent cooling, out-of-date software, and uneven air distribution, since the module controls the whole AC system.
How to Obtain an A2 ASE Study Guide and Practice Test
Automotive technician jobs pay more if you’re ASE certified. Get the study guide and tests for A2 Automatic Transmission/Transaxle technicians.
How to Check Your Car Brake Lights
Car brake lights are essential for driving safely. Check the brake lights and brake fuses regularly to keep the brake system working well.

when cranked up it revs up and down

Hello. This is a common issue in the 7.3 Liter Ford Diesels. There is something called an ICP (Injection Control Pressure) sensor (https://www.yourmechanic.com/services/injector-control-pressure-sensor-replacement) which is located at the front of the motor on the driver's side near the fuel filter....

Can I remove with EPC solenoid and wiring harness without removing the valve body?

The solenoid may be removed without removing the valve body, however, the valve body will need to be removed in order to get the harness out safely without damaging it. There are two bolts that hold the solenoid in as...

I put my car in drive but it won't go but it will go in reverse what could be wrong

Hi There, What you are describing may be a result of a faulty speed sensor, potentially low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a even a faulty transmission control solenoid. As your vehicle travels down the road, the computer analyzes data being...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com