GMC Savana 2500 Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(31)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(31)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a GMC Savana 2500 Water Pump Replacement is $278 with $138 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2000 GMC Savana 2500V8-5.7LService typeWater Pump ReplacementEstimate$622.94Shop/Dealer Price$708.38 - $948.48
2016 GMC Savana 2500V8-4.8LService typeWater Pump ReplacementEstimate$945.21Shop/Dealer Price$1077.52 - $1462.08
2007 GMC Savana 2500V8-4.8LService typeWater Pump ReplacementEstimate$960.22Shop/Dealer Price$1124.07 - $1606.42
2009 GMC Savana 2500V8-4.8LService typeWater Pump ReplacementEstimate$960.22Shop/Dealer Price$1124.06 - $1606.41
2006 GMC Savana 2500V6-4.3LService typeWater Pump ReplacementEstimate$1061.24Shop/Dealer Price$1253.58 - $1814.12
2014 GMC Savana 2500V8-6.0LService typeWater Pump ReplacementEstimate$960.22Shop/Dealer Price$1124.37 - $1606.95
2009 GMC Savana 2500V8-6.0LService typeWater Pump ReplacementEstimate$960.22Shop/Dealer Price$1124.10 - $1606.47
1996 GMC Savana 2500V8-6.5L Turbo DieselService typeWater Pump ReplacementEstimate$859.95Shop/Dealer Price$977.95 - $1320.23
Show example GMC Savana 2500 Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert GMC mechanics

Real customer reviews from GMC owners like you.

Excellent Rating

(31)

Rating Summary
30
0
1
0
0
30
0
1
0
0

Jerome

17 years of experience
68 reviews
Jerome
17 years of experience
GMC Savana 2500 V8-4.8L - Car is not starting - Hyattsville, Maryland
Jerome did the best he could with very little information. He was asked to diagnose a vehicle that wouldn't start. His conclusion was that it needed to be sent to the dealership for closer examination. In reality, it just needed a new alternator, a problem common for vehicles that won't start. Jerome's diagnosis set-off a series of errands and phone calls which were all unnecessary, and very frustrating. I'm providing three stars, because he had very little information to go by, but in the end, it was a very frustrating experience.

Peter

44 years of experience
1397 reviews
Peter
44 years of experience
GMC Savana 2500 V8-5.0L - Center (Drag) Link - Avondale, Arizona
Wonderful!!! So knowledgeable!! Excellent mechanic!

Stephen

33 years of experience
220 reviews
Stephen
33 years of experience
GMC Savana 2500 V8-4.8L - Oil Change - Denver, Colorado
Steve was prompt,went right to work. It was very easy to see he was a true professional with all the tools of his trade. No doubt he has done this a very lengthy time. I will continue to do business with him for the foreseeable future.

Troy

41 years of experience
107 reviews
Troy
41 years of experience
GMC Savana 2500 V8-5.0L - Distributor - Phoenix, Arizona
He was very professional And explained everything that was wrong with my vehicle

Excellent Rating

(31)

Rating Summary
30
0
1
0
0
30
0
1
0
0
Number of GMC Savana 2500 services completed
341+
services done by our mechanics
TOTAL NUMBER OF EXPERT GMC MECHANICS
900+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Cruise Control Brake Release Switch
If your cruise control system cuts off unexpectedly or stays on even when brakes are applied, replace the cruise control brake release switch.
How Long Does a Starter Last?
You turn the key in the ignition of your car and the engine cranks – that’s about as far as most drivers get...
Symptoms of a Bad or Failing Transfer Case Output Shaft Seal
Common signs include difficulty shifting gears, grinding noises coming from underneath the vehicle, and jumping in and out of four-wheel drive.

Noisy steering and bad performance, is this dangerous?

There is a technical service bulletin (TSB) pertaining to a clicking or thud type noise when turning that may pertain to your vehicle. The TSB number 14-ST-002-1 dated May 2014 is to address the clicking or thud issue by replacing...

Air cleaner housing clamp

The best solution be to get the other clip back on the air box, so that the box will fully seal. Unfortunately since the air box is made of molded plastic, and a piece of it has broken off, it...

My car won't accelerate although I replaced the throttle body and the accelerator pedal.

Hi there. Check the Idle Air Control valve (IAC) and see if it's sticking or not working. The IAC valve controls the engine's idle and keeps the engine at an optimal operating speed when the throttle is pushed or not....

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com