GMC R2500 Suburban Power Steering Pump Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a GMC R2500 Suburban Power Steering Pump Replacement is $283 with $101 for parts and $182 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1991 GMC R2500 SuburbanV8-6.2L Diesel	Service typePower Steering Pump Replacement	Estimate$440.14	Shop/Dealer Price$504.48 - $686.97
1991 GMC R2500 SuburbanV8-5.7L	Service typePower Steering Pump Replacement	Estimate$428.43	Shop/Dealer Price$490.47 - $671.24
1990 GMC R2500 SuburbanV8-7.4L	Service typePower Steering Pump Replacement	Estimate$428.43	Shop/Dealer Price$490.50 - $671.30
1990 GMC R2500 SuburbanV8-5.7L	Service typePower Steering Pump Replacement	Estimate$428.43	Shop/Dealer Price$490.50 - $671.29
1990 GMC R2500 SuburbanV8-6.2L Diesel	Service typePower Steering Pump Replacement	Estimate$428.43	Shop/Dealer Price$492.42 - $674.65
1991 GMC R2500 SuburbanV8-7.4L	Service typePower Steering Pump Replacement	Estimate$428.43	Shop/Dealer Price$490.68 - $671.61

Show example GMC R2500 Suburban Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
The threaded connectors to the pump inlet and outlet are loosened and removed.
Any mounting bolts and brackets are removed so the pump can be removed.
If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert GMC mechanics

Real customer reviews from GMC owners like you.

Excellent Rating

(37)

Rating Summary

35

1

0

1

0

35

1

0

1

0

SEE REVIEWS NEAR ME

Jason

21 years of experience

26 reviews

Jason

21 years of experience

by James

GMC Sonoma V6-4.3L - Power Steering Pump Replacement - Atlanta, Georgia

Great

Noe

37 years of experience

604 reviews

Noe

37 years of experience

by Tim

GMC Sierra 1500 V8-5.3L - Power Steering Pump Replacement - Renton, Washington

Noe did a great job!!

Drew

12 years of experience

17 reviews

Drew

12 years of experience

by james

GMC G2500 V8-5.7L - Power Steering Pump - Charlotte, North Carolina

Drew was on time and did a great job replacing my power steering pump.Would certainly use again.

Joe

44 years of experience

838 reviews

Joe

44 years of experience

by Joey

GMC Sierra 1500 V8-4.8L - Power Steering Pump - Tampa, Florida

Perfect

Excellent Rating

(37)

Rating Summary

35

1

0

1

0

35

1

0

1

0

SEE REVIEWS NEAR ME

Recent articles & questions

How to Get Better Gas Mileage with Your Toyota Prius

The The Toyota Prius is considered one of the cleanest, environmentally friendly vehicles to drive based on the amount of smog-forming emissions that most other vehicles put out. The Prius is a full hybrid electric vehicle that combines the use...

Symptoms of a Bad or Failing Manifold Absolute Pressure Sensor (MAP Sensor)

Common signs of manifold absolute pressure sensor problems include excessive fuel consumption, lack of power, and failing an emissions test.

How Often Do Oil Filters Need to Be Replaced?

Depending on who you...

Permanent DTC?

Hi there. It is possible that the 09 Sienna may have permanent codes. If it does, this is only for informational purposes for a qualified technician. These codes will clear themselves once a specified number of drive cycles without the...

Steering issues

The spring is compressed between the spring seat on the strut and a top cap that is held on by the strut retaining nut. When you turn the wheel the spring will move as the strut itself moves. So, movement...

I have a 2017 Volkswagen Passat dome lights

There is usually a spring loaded switch in the door pillar. The switch contacts may be stuck closed even after you shut the door. If that is not the issue, and you were to request that a mechanic identify the...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com