Geo Storm Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(78)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(78)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Geo Storm Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1990 Geo StormL4-1.6LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1993 Geo StormL4-1.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1991 Geo StormL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1992 Geo StormL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1993 Geo StormL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1992 Geo StormL4-1.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Geo Storm Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Geo mechanics

Real customer reviews from Geo owners like you.

Excellent Rating

(78)

Rating Summary
72
5
0
0
1
72
5
0
0
1

Whitney

39 years of experience
783 reviews
Whitney
39 years of experience
Geo Storm L4-1.6L - Alternator - Santa Clara, California
Whitney is a true professional. Showed up to the appointment at least an hour before the actual scheduled time! Because of this, we were able to start work on my car earlier than expected (which is a good thing). There are still some other things that need to be done with my car, since I didn't want to spend a boat load of money in one sitting. I hope to work with Whitney again, and would highly recommend YourMechanic to my friends and family.

Curtis

29 years of experience
163 reviews
Curtis
29 years of experience
Geo Prizm L4-1.6L - Radiator - Waynesboro, Georgia
Knowledgeable, able to answer any question and goes above and beyond to complete the job. Will be booking again with Curtis.

Wesley

16 years of experience
277 reviews
Wesley
16 years of experience
Geo Prizm L4-1.8L - Car is not starting - Wheat Ridge, Colorado

Duane

25 years of experience
512 reviews
Duane
25 years of experience
Geo Tracker L4-1.6L - Car AC Repair - San Diego, California
Duane is a real professional. It's a real relief when you know a pro is taking care of your ride. Thanks, Duane!

Excellent Rating

(78)

Rating Summary
72
5
0
0
1
72
5
0
0
1
Number of Geo services completed
858+
services done by our mechanics
TOTAL NUMBER OF EXPERT Geo MECHANICS
70+
experts on our platform

Recent articles & questions

Is It Safe to Drive While Taking Pain Killers?
If If you have been taking strong painkillers, we hope that you have been reading the instructions on your medication label. Chances are, you will find a phrase that reads something like this: “This product may cause drowsiness. Avoid using...
Symptoms of a Bad or Failing ECM-Power Relay
If there is no power when the key is inserted, the engine will not start, or the battery is dead, you may need to replace the ECM power relay.
How to Put a Truck Cap on Your Pickup
Truck caps go on pickup truck beds to protect items from weather and theft. Camper shells, canopies, truck caps, and work caps are common cap styles.

Why caution should be observe during compression test?

You should disable the fuel pressure pump and spark of the ignition. This way you do not burn out the ignition system and flood the engine with fuel. The best way to do a compression test (https://www.yourmechanic.com/article/how-to-do-a-compression-test-by-robert-tomashek) is to operate...

Recently had the IMRC rotary valve assembly replaced. One day later and I'm getting P1078.

Hi there. Some additional diagnostic tests will be necessary to identify the problem. The P1078 (https://www.yourmechanic.com/article/p0178-obd-ii-trouble-code-fuel-composition-sensor-circuit-low-input-by-jay) testing diagrams show that there are possible issues with a solenoid valve, a sensor, a vacuum leak, or an electrical issue. A certified mechanic...

Serpentine belt popped off engine while running

Hello there, many faults will cause the drive belt on your 2007 Dodge Durango to fall off. In many cases the belt comes off from either a seized pulley, or a pulley that is walking. If your harmonic balancer pulley...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com