Dodge Stratus Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(223)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(223)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Dodge Stratus Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1995 Dodge StratusL4-2.4LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1999 Dodge StratusL4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1995 Dodge StratusL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2000 Dodge StratusV6-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2001 Dodge StratusV6-2.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2004 Dodge StratusL4-2.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2004 Dodge StratusV6-2.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2002 Dodge StratusV6-2.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Dodge Stratus Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Dodge mechanics

Real customer reviews from Dodge owners like you.

Excellent Rating

(223)

Rating Summary
201
16
2
0
4
201
16
2
0
4

Mathew

6 years of experience
57 reviews
Mathew
6 years of experience
Dodge Stratus V6-2.7L - Battery - Philadelphia, Pennsylvania
Great mechanic i would recommend anybody to this kind man and highly reliable.

Matthew

33 years of experience
1222 reviews
Matthew
33 years of experience
Dodge Stratus V6-2.7L - Car is not starting - Norfolk, Virginia
awesome work

Genaro

13 years of experience
287 reviews
Genaro
13 years of experience
Dodge Stratus V6-2.7L - Alternator - Houston, Texas
On time and fast

Matthew

33 years of experience
1222 reviews
Matthew
33 years of experience
Dodge Stratus V6-2.7L - Check Engine Light is on - Newport News, Virginia
Showed early to my house for being such a beast with his previous appointments and Broke it down what i needed

Excellent Rating

(223)

Rating Summary
201
16
2
0
4
201
16
2
0
4
Number of Dodge Stratus services completed
2453+
services done by our mechanics
TOTAL NUMBER OF EXPERT Dodge MECHANICS
1400+
experts on our platform

Recent articles & questions

What Are the Best Spark Plugs for Normal Use?
Spark Spark plugs are essential components of your ignition system. They’re responsible for supplying the spark that ignites fuel and starts the combustion process. However, not all spark plugs are created equal. You’ll find “normal” plugs on the market, but...
P2509 OBD-II Trouble Code: ECM/PCM Power Input Signal Intermittent
P2509 P2509 code definition The P2509 diagnostic trouble code is an indication that the ECM/PCM power input signal is having an intermittent problem. Related Trouble Codes: P2505 OBD-II Trouble Code: ECM/PCM Power Input Signal P2506 OBD-II Trouble Code: ECM/PCM Power...
The Guide To Colored Curb Zones in Florida
Florida Florida Parking Laws: Understanding the basics Drivers in the state of Florida need to be aware of where they are parking their vehicles to ensure they are not breaking the law. While most drivers are well aware of the...

Truck wont start gives check engine light ran fine yesterday

Hi there. The Check Engine Light (https://www.yourmechanic.com/article/what-does-the-check-engine-warning-light-mean) is a warning system that illuminates when an OBD-II error code is triggered. There are literally hundreds of possible reasons why the Check Engine will light up. In most cases, this is caused...

What size bolt should I use?

Hi - From your description, I'm not sure which bolt you are referring to, but you can measure both bolt diameter and pitch to determine the answer to your question. The pitch can be measured with a thread pitch gauge...

hi i have a 1997 honda accord and when you push down on the clutch it makes a grinding sound and i cant put it into first without

From your description, I would say that your clutch is due for a replacement. If there was a mechanical issue inside the transmission, the shifter would be hard to move even with the engine off. Since the clutch assembly is...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com