Chevrolet Aveo Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(238)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(238)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Chevrolet Aveo Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2005 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2007 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2011 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2008 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2006 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2010 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2004 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2009 Chevrolet AveoL4-1.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Chevrolet Aveo Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(238)

Rating Summary
214
12
2
4
6
214
12
2
4
6

Justin

16 years of experience
88 reviews
Justin
16 years of experience
Chevrolet Aveo L4-1.6L - Thermostat - Sacramento, California
Justin did a great job explaining what I need. He also showed me and explained why. I believe Justin's honesty makes him exceptional.

Juan

29 years of experience
70 reviews
Juan
29 years of experience
Chevrolet Aveo L4-1.6L - Brake Pads Replacement (Front) - Northridge, California

Tung

16 years of experience
310 reviews
Tung
16 years of experience
Chevrolet Aveo L4-1.6L - Brakes, Steering and Suspension Inspection - Marietta, Georgia
Tung is very nice he explain to me what he was getting ready to do you show me what was I need it for my car and he gave me a recommendation on what needs to be fixed right away and why I shouldn't drive it until it was completely repaired he took his time to make sure I understood what I need it for my car me and my family really appreciate him. He's very knowledgeable what's wrong with my car which I feel very comfortable with him doing so since my son is the only one who ever worked on my car thanks you.

Richard

21 years of experience
461 reviews
Richard
21 years of experience
Chevrolet Aveo L4-1.6L - Check Engine Light is on - Fairburn, Georgia
My Chevy Aveo would not start and the check engine light was on Richard got my car started and found out what was wrong with it Oxygen Sensor need to be replaced Thanks so very much for helping me and explaining everything God's blessings today and always

Excellent Rating

(238)

Rating Summary
214
12
2
4
6
214
12
2
4
6
Number of Chevrolet Aveo services completed
2618+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1600+
experts on our platform

Recent articles & questions

Top 5 Reasons to Be a Mobile Technician
Automotive technician jobs can be a great career choice. Find out if a mechanic job as a mobile technician is right for you.
P2552 OBD-II Trouble Code: Throttle/Fuel Inhibit Circuit
P2552 P2552 code definition A P2552 OBD-II trouble code indicates a problem with the throttle or fuel inhibitor circuit. This is a malfunction more commonly found in diesel-powered vehicles. This code is also associated with OBD-II trouble codes P2553, P2554,...
How to Maximize the Value of Your Vehicle
As As soon as you buy a new car, its value starts to decrease. The ultimate value of your car is a combination of its age, mileage (https://www.yourmechanic.com/article/how-to-easily-increase-your-gas-mileage-by-jason-unrau), and overall condition of your vehicle. Luckily, you have control over two...

Gear always in Drive

I'm assuming that you mean that the D4 light is lit up on the dash not that the transmission is in gear. The D4 light indicates a problem with the electrical system, and codes will need to be pulled off...

I have owned a Buick regal for 13 years and would like to purchase a new car.

Hello. Since I cannot recommend any certain vehicle, I will try to assist you with your purchase as much as I am able. Websites like Edmonds.com and kbb.com are excellent for determining pricing, reliability, safety, and luxury. Also, check websites...

P0705 - 2007 Scion tC

Hello and thanks for contacting YourMechanic. The code P0705 (https://www.yourmechanic.com/article/p0705-obd-ii-trouble-code-transmission-range-sensor-circuit-malfunction-prndl-input-by-blake-griffin) means the transmission range sensor circuit has a fault. This is usually caused by the sensor on the transmission failing. After installing the remote start switch, if you did not...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com