BMW M550i xDrive Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6,758)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6,758)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a BMW M550i xDrive Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2018 BMW M550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2019 BMW M550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2021 BMW M550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2020 BMW M550i xDriveV8-4.4L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
Show example BMW M550i xDrive Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(6,758)

Rating Summary
6,302
206
60
45
145
6,302
206
60
45
145

Travis

13 years of experience
600 reviews
Travis
13 years of experience
BMW X5 L6-3.0L Turbo - Reduced Power light is on Inspection - Saint Paul, Minnesota
He was very professional and nice

Richard

11 years of experience
450 reviews
Richard
11 years of experience
BMW 528i xDrive L4-2.0L Turbo - Fuel Pressure Sensor Replacement - Houston, Texas
Its fast action

Robert

21 years of experience
64 reviews
Robert
21 years of experience
BMW 335i L6-3.0L Turbo - Spark Plugs - Redmond, Washington
Robert did a great job and was professional at the work and also did the fluid leak diagnosis and explained the diagnosis very well.

Estevan

12 years of experience
41 reviews
Estevan
12 years of experience
BMW 530i L4-2.0L Turbo - Brake Pads Replacement (Front) - Lake Elsinore, California
Appreciate the ease of getting this done. High quality work!

Excellent Rating

(6,758)

Rating Summary
6,302
206
60
45
145
6,302
206
60
45
145
Number of BMW services completed
74338+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

P2555 OBD-II Trouble Code: Throttle/Fuel Inhibit Circuit High
P2555 means there is a problem with the FICM (fuel injection control module). The FICM regulates how much fuel is delivered by the fuel injectors.
How to Check and Add Fluid to an Automatic Transmission Car
Checking and keeping your transmission filled with a good level of fluid will help give you a seamless experience when driving.
P0447 OBD-II Trouble Code: Evaporative Emission Control System Vent Control Circuit Open
P0447 means there is a component in the EVAP control system that is malfunctioning, likely due to a faulty fuel cap, solenoid, hose, or sensor.

Bad clutch

If the clutch is slipping, then a new clutch will most likely need to be installed. The flywheel will need to be inspected and possibly machined, if there are gouges or hotspots. You may want to enlist the help of...

Car stalling while driving - 2006 Pontiac Grand Prix

Hi there. The P0033 OBD-II error code (https://www.yourmechanic.com/article/p0033-obd-ii-trouble-code-turbo-charger-or-supercharger-bypass-valve-control-circuit-deleted-by-john-nelson) is a generic code that typically indicates a problem with the Turbocharger or Supercharger Bypass Valve Control Circuit. In most cases, the reason the code is triggered is due to a vacuum...

What are the signs my Timing Chain needs to be replaced?

Hi there. The noise that you are hearing could be either the timing chain or the variable valve timing solenoids. If the sound is constant and rattles easy and does not bog down the engine, then the timing chain is...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com