BMW 330xi Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(43)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(43)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a BMW 330xi Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2006 BMW 330xiL6-3.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2002 BMW 330xiL6-3.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2005 BMW 330xiL6-3.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2003 BMW 330xiL6-3.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2004 BMW 330xiL6-3.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2001 BMW 330xiL6-3.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example BMW 330xi Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(43)

Rating Summary
39
2
2
0
0
39
2
2
0
0

Collins

12 years of experience
496 reviews
Collins
12 years of experience
BMW 330xi L6-3.0L - Axle / CV Shaft Assembly Replacement (Driver Side Front, Passenger Side Front) - Atlanta, Georgia
Extremely pleasant.

Emmette

36 years of experience
282 reviews
Emmette
36 years of experience
BMW 330xi L6-3.0L - Leak Detection Pump - Woodbridge, Virginia
Emmettes was on time, professional & got right to work. Thank you.

Damian

11 years of experience
465 reviews
Damian
11 years of experience
BMW 330xi L6-3.0L - Stabilizer Bar Links Replacement (Front) - Beltsville, Maryland
guy knows his stuff and is very friendly. I gave him the parts, and he knocked out the labor without a single problem. made it look easy.

Fred

17 years of experience
389 reviews
Fred
17 years of experience
BMW 330xi L6-3.0L - Check Engine Light is on - Conroe, Texas
Very smart man! After 4 monkeys screwed up my oil change at Take 5, my 2006 BMW had a check engine light. Fred deftly identified the problem, are solved it, and gave me peace of mind. Man knows his business! Professional, honest, and patient with my babbling lol. I’m recommending him to family and everyone I know.

Excellent Rating

(43)

Rating Summary
39
2
2
0
0
39
2
2
0
0
Number of BMW 330xi services completed
473+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

Is it Safe to Drive With One Hand?
According According to esure (http://www.esure.com/media_centre/archive/driving_one_hand.html), two million drivers have had an accident, or near accident while driving with just one hand. An academic report that came out in April of 2012 showed that driving with two hands is better than...
P0649 OBD-II Trouble Code: Speed Control Lamp Control Circuit
P0649 means the PCM has detected a problem with the speed control lamp circuit due to a faulty speed control lamp bulb or circuit, wiring issues.
Mechanics Who Come to You
Benefits of Using a Mobile Mechanic Instead of Driving Your Car to a Shop

How do I remove the spare tire?

Removing the spare tire is an important step when fixing a flat tire. This is what will replace it. To remove the spare tire. Locate the tire tool set. Look under the rear of the bed and the spare tire...

I have a screw in my front tire. Can I park on it tonight before going to the tire shop ASAP tomorrow morning!

What you should do is spray the screw with some soapy water to see if you see any air bubbles indicating a leak. If you do not see a leak then try and move the screw side to side to...

Was told mount broke off..and need to replace 3 to secure transmussion..also that bed housing could be damaged

What you are describing is possible. Vehicle components can only withstand so much force and beyond that they will break. As far as the bell housing of the transmission, if that housing is cracked, replacing that is a fairly significant...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com