BMW 330i xDrive Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6,828)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6,828)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a BMW 330i xDrive Reduced Power light is on Inspection is $105 with $0 for parts and $105 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2020 BMW 330i xDriveL4-2.0L TurboService typeReduced Power light is on InspectionEstimate$124.99Shop/Dealer Price$133.39 - $139.69
2021 BMW 330i xDriveL4-2.0L TurboService typeReduced Power light is on InspectionEstimate$104.99Shop/Dealer Price$113.41 - $119.72
2017 BMW 330i xDriveL4-2.0L TurboService typeReduced Power light is on InspectionEstimate$104.99Shop/Dealer Price$113.41 - $119.72
2019 BMW 330i xDriveL4-2.0L TurboService typeReduced Power light is on InspectionEstimate$104.99Shop/Dealer Price$113.39 - $119.68
2022 BMW 330i xDriveL4-2.0L TurboService typeReduced Power light is on InspectionEstimate$104.99Shop/Dealer Price$113.42 - $119.75
2018 BMW 330i xDriveL4-2.0L TurboService typeReduced Power light is on InspectionEstimate$104.99Shop/Dealer Price$113.41 - $119.72
Show example BMW 330i xDrive Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(6,828)

Rating Summary
6,369
206
60
45
148
6,369
206
60
45
148

Luis

18 years of experience
329 reviews
Luis
18 years of experience
BMW 330i xDrive L4-2.0L Turbo - Oil Change - Scotch Plains, New Jersey
Luis is great!

Shawn

12 years of experience
315 reviews
Shawn
12 years of experience
BMW 330i xDrive L4-2.0L Turbo - Oil Change - Plymouth Meeting, Pennsylvania
Fantastic experience!

Travis

13 years of experience
611 reviews
Travis
13 years of experience
BMW X5 L6-3.0L Turbo - Reduced Power light is on Inspection - Saint Paul, Minnesota
He was very professional and nice

Dave

23 years of experience
303 reviews
Dave
23 years of experience
BMW 325i L6-2.5L - Thermostat - Sunnyvale, California
Keep it up!

Excellent Rating

(6,828)

Rating Summary
6,369
206
60
45
148
6,369
206
60
45
148
Number of BMW services completed
75108+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

P0304 OBD-II Trouble Code: Cylinder 4 Misfire Detected
P0304 code definition P0304 is a diagnostic trouble code seen when a misfire is detected in cylinder 4. This code may...
Saab Certified Pre-Owned (CPO) Car Program
Many Many drivers who are in the market for a used Saab vehicle want to consider a Certified Pre-Owned, or CPO, vehicle. CPO programs allow owners of used cars to drive with confidence, knowing that their vehicle has been inspected...
P0703 OBD-II Trouble Code: Torque Converter/Brake Switch B Circuit Malfunction
P0703 Code means the PCM has registered a fault in the brake switch B circuit due to failed brake lamp switch, faulty fuse or socket

High idle and car won't stop

Hello. This sounds like it may be a faulty Mass Air Flow sensor or a throttle arm that could be stuck. It could also be an air leak. A good way to test for leaks is to spray starting fluid...

My truck struggles to start and stay running

This sounds like a fuel pump that is weak to start the vehicle and then stops pumping after ten minutes when it heats up. Have the fuel pressure checked to see if it is holding pressure and keeps pressure when...

My 2006 VW Jetta 2.5 jerks when driving it and sometimes goes into limo mode ... It does needs a new catalytic converter . It star

Hi Jay. Thanks for contacting us tonight. There are several reasons why your vehicle activates a limp mode - but most of them related to the transmission itself. A clogged catalytic converter will restrict the efficient flow of exhaust, and...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com