BMW 325xi Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(70)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(70)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a BMW 325xi Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2003 BMW 325xiL6-2.5LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2005 BMW 325xiL6-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2004 BMW 325xiL6-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2006 BMW 325xiL6-3.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2001 BMW 325xiL6-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2002 BMW 325xiL6-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example BMW 325xi Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert BMW mechanics

Real customer reviews from BMW owners like you.

Excellent Rating

(70)

Rating Summary
62
3
1
0
4
62
3
1
0
4

Derek

23 years of experience
71 reviews
Derek
23 years of experience
BMW 325xi L6-2.5L - Clutch is not working - Denver, Colorado
Very honest and a huge help.

Robert

20 years of experience
1092 reviews
Robert
20 years of experience
BMW 325xi L6-2.5L - Car is not starting - Denver, Colorado
Great

Attila

19 years of experience
910 reviews
Attila
19 years of experience
BMW 325xi L6-2.5L - Car is not starting - Keasbey, New Jersey
I liked that he knew exactly what he was talking about with my car. he was honest, and patient with the entire process of trying to come to a valid conclusion. I appreciated his service, he was kind, and very considerate. I would recommend him to anyone with foreign cars and needs some assistance in trying to get honest answers for half the price! If I have anymore problems, I definitely will be giving him a call to get the job done right and accurately. 2 thumbs up, and five stars to great customer service!

John

19 years of experience
138 reviews
John
19 years of experience
BMW 325xi L6-3.0L - Check Engine Light is on - Georgetown, Texas
John showed up on time and was very courteous and professional. After reviewing our car gave us an honest assessment of what it would take to fix the car and other fixes to avoid future problems.

Excellent Rating

(70)

Rating Summary
62
3
1
0
4
62
3
1
0
4
Number of BMW 325xi services completed
770+
services done by our mechanics
TOTAL NUMBER OF EXPERT BMW MECHANICS
1100+
experts on our platform

Recent articles & questions

Is There a Way to Reduce Glare From Car Mirrors?
We’ve We’ve all experienced it before. You’re driving along minding your own business when someone gets behind you. You know they’re not driving with their high beams on, but it seems like they’re glaring right in your eyes from your...
How Long Does a Pinion Seal Last?
Front-wheel Front-wheel drive cars have CV axles that transmit power from the transmission to the wheels. However, in a rear-wheel drive system, a drive shaft connects to the transmission and transmits power to the rear differential. The driveshaft connects to...
Windshield Laws in Delaware
If If you’re a driver, you already know that there are a lot of rules that you have to follow when travelling the roadways in Delaware. However, traffic laws include considerably more than just what you do while you are...

Error 100 reading on the odometer. Battery fuses and starter are all good. My car won't crank.

Hello and thank you for contacting YourMechanic. Check the engine control module (ECM) (https://www.yourmechanic.com/article/symptoms-of-a-bad-or-failing-engine-control-module-ecm) for an open short to ground. Check the battery's (https://www.yourmechanic.com/article/how-to-check-a-car-battery) positive voltage input circuits, the battery positive voltage output circuits, the ignition voltage input circuits, the...

how much damage to engine after driving after serpentine belt broke?

Hi there. I'll be transparent with you, there is no way for me to determine the extent of the damage or what it may cost without performing an inspection on the vehicle. During the last service were you provided with...

Unable to bleed fuel tank

Hi There, It sounds like you may have a faulty vent valve solenoid. The vent control valve (solenoid) controls the flow of outside air in and out of the charcoal canister. When this is not working properly, you may experience...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com