Audi TT Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(46)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(46)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Audi TT Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2002 Audi TTL4-1.8L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2004 Audi TTL4-1.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2001 Audi TTL4-1.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2006 Audi TTL4-1.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2000 Audi TTL4-1.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2005 Audi TTL4-1.8L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2009 Audi TTL4-2.0L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.28 - $130.25
2003 Audi TTL4-1.8L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$117.94 - $131.39
Show example Audi TT Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Audi mechanics

Real customer reviews from Audi owners like you.

Excellent Rating

(46)

Rating Summary
43
1
0
1
1
43
1
0
1
1

Jonathan

26 years of experience
18 reviews
Jonathan
26 years of experience
Audi TT L4-1.8L Turbo - Thermostat - Palo Alto, California
Jonathan was extremely nice and polite, yet in my first drive after he worked on my car there are sounds from the engine that weren't there before and a service light went on (also, wasn't there before). Considering the fact that the first mechanic you sent simply didn't show up, wasn't available when I called to check if he is coming, and also that the main costumer service didn't answer - I am VERY disappointed by the service I got...

Theodore

16 years of experience
1592 reviews
Theodore
16 years of experience
Audi TT L4-2.0L Turbo - Thermostat - Woodinville, Washington
It is really a pleasant to have Theodore to take care of my issue. After 5 fours of his hard work, my problem has gone and the car is all right after that.

Jason

17 years of experience
429 reviews
Jason
17 years of experience
Audi TT L4-1.8L Turbo - Crankshaft Position Sensor Replacement - Pleasanton, California
Yourmechanic helped fixed a couple of issues in my car. There was a crank sensor issue, and Jason C fixed it very well. He took time, and diagnosed the problem very well, and then did a wonderful job, setting the car right.

Gregory

17 years of experience
37 reviews
Gregory
17 years of experience
Audi TT L4-1.8L Turbo - Pre-purchase Car Inspection - Hialeah, Florida
Unbelievable knowledge, he gave me the information and confidence to make a safe decision on this vehicle. Gregory's recommendations were fantastic, so he saved me from wasting hard earned money on a bad investment. Thank you so much Gregory for your time yesterday

Excellent Rating

(46)

Rating Summary
43
1
0
1
1
43
1
0
1
1
Number of Audi TT services completed
506+
services done by our mechanics
TOTAL NUMBER OF EXPERT Audi MECHANICS
700+
experts on our platform

Recent articles & questions

How to Get Honda Dealership Certified
Honda car dealerships offer automotive technician jobs to mechanics who are certified through the many training programs available.
P0413 OBD-II Trouble Code: Secondary Air Injection System Switching Valve A Circuit Open
P0413 means theres a issue with the vehicle’s air injection system due to faulty air injection pump, faulty wiring or faulty air bypass solenoid.
P0786 OBD-II Trouble Code: Shift/Timing Solenoid Range/Performance
P0786 means there is a problem with the shift/timing solenoid due to a low fluid levels, faulty solenoid, or internal transmission components.

Slow slipping transmission, how much longer will it last?

If you are out of warranty, you'll need to have your vehicle checked for problems with a qualified technician such as YourMechanic. They can come to your home or office, perform a road test, check your transmission for mechanical or...

Car wont start but cranks 1998 Nissan Altima

Hey there, thanks for writing in about your 1998 Altima. You may have a crankshaft (https://www.yourmechanic.com/services/crankshaft-position-sensor-replacement) or camshaft sensor (https://www.yourmechanic.com/services/camshaft-position-sensor-replacement) causing the no start. You can scan the computer and watch the data to see if one or both of...

I have no ignition, or dash lights when turning key. All relays and battery are fine. Dash lights work when headlights are on.

You may have a bad connection in the connectors to the body control module, instrument cluster, and ECM. Try to disconnect the battery and disconnect these modules. Afterwards, apply dielectric lube to the connectors and reconnect the battery and see...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com