Acura CSX Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Acura CSX Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2006 Acura CSXL4-2.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2011 Acura CSXL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2008 Acura CSXL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2009 Acura CSXL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2010 Acura CSXL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
2007 Acura CSXL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
Show example Acura CSX Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Acura mechanics

Real customer reviews from Acura owners like you.

Excellent Rating

(6)

Rating Summary
6
0
0
0
0
6
0
0
0
0

Kenneth

16 years of experience
113 reviews
Kenneth
16 years of experience
Acura RL V6-3.5L - Car starts and then dies - Oakland, California
Kenneth go above and beyond to resolve issues, he has my recommendation

Brandon

18 years of experience
275 reviews
Brandon
18 years of experience
Acura MDX V6-3.7L - Car starts and then dies - Loganville, Georgia
Brandon was very professional, knowledgeable and timely

Abdul

11 years of experience
419 reviews
Abdul
11 years of experience
Acura MDX V6-3.5L - Car starts and then dies - Atlanta, Georgia
Abdul was punctual, professional and helpful with explaining the issues he found with my car.

Darnell

19 years of experience
21 reviews
Darnell
19 years of experience
Acura RDX L4-2.3L Turbo - Car starts and then dies - Marina Del Rey, California
Fantastic experience. He was professional and capable.

Excellent Rating

(6)

Rating Summary
6
0
0
0
0
6
0
0
0
0
Number of Acura Car starts and then dies Inspection services completed
66+
services done by our mechanics
TOTAL NUMBER OF EXPERT Acura MECHANICS
1000+
experts on our platform

Recent articles & questions

How Do Headlight Wipers Work?
Headlight Headlight wiper systems are only seen on a very small portion of vehicles on the road today, which is why most people aren’t aware of how they operate. Their purpose is simply to provide a clean headlight lens for...
P0131 OBD-II Trouble Code: O2 Sensor Circuit Low Voltage Bank 1 Sensor 1
P0131 code definition The P0131 code is low sensor voltage for oxygen sensor bank 1 sensor 1 or improper air fuel ratio....
P0446 OBD-II Trouble Code: Evaporative Emission Control System Vent Control Circuit Malfunction
P0446 code definition P0446 is an OBD2 diagnostic trouble code that indicates a fault within the evaporative emission control system. Other EVAP...

Clutch slave cylinder causes clutch pedal malfunction

Hi there, thanks for writing in about your 2012 Nissan 370Z. The clutch assembly shouldn't be worn out at 50,000 miles unless the vehicle has been abused. There are many concerns for vehicles that match your model year with the...

Hi my water tank has been leaking for a few days while i wait for the parts to come in .

Has the engine been run while overheating to the point where the engine shut off? The engine power is reduced warning message has come on because the vehicles computer picked up a problem in the control system. There may be...

Chrysler 300 C 2012.... battery saver mode

If there is an unusual odor (you refer to a burning odor), I would not drive the car. Other than the odor issue, based on what you are describing you are not going to worsen the situation. A particular concern,...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com