The The 2012 Nissan Murano is a sleek crossover SUV that has all the modern amenities. It has ample interior space with a luxurious feel, and a driver oriented suspension. If you need a vehicle that can hold passengers and...
I would recommend Consulting with the dealership that recommended the replacement of the ECM. If the old ECM was good this would be considered a missed diagnosis on the part of the dealership.
If the engine just revs up after you put it into gear, I would suspect a transmission problem. But if you don't have any control over engine speed it's likely a linkage malfunction between the pedal and throttle body, or...
Hello. Code P0340 (https://www.yourmechanic.com/article/p0340-obd-ii-trouble-code-camshaft-position-sensor-circuit-malfunction-by-jamahl-walker) sets due to many possible faults. The sensors themselves have to be tested using an oscilloscope to see if the output waveform meets spec. If the sensors were not tested, there may have been nothing wrong...
This may be related to many different possibilities, some of which may be related to a lack of spark and some of which may be related to a fuel delivery problem or a combination of both. For example, if the...
Hello, thank you for writing in. The main component that is in charge of turning off and on the vehicle is the ignition switch. You will likely want to start by inspecting and potentially replacing this switch. To truthfully know...
Hi Taylor. Thanks for contacting us today. Without knowing the symptoms your car is displaying, it's hard for us to give you an accurate suggestion here. I've always believed that if one sensor has failed or is faulty, others will...
It sounds like you may have a blown head gasket causing coolant to get into the engine cylinders. You will need to have the cooling system pressure tested and compression test done to verify the blown head gasket and need...
It is possible that you could be having an issue with your transmission. I would recommend having your transmission inspected by a qualified transmission specialist to determine the exact cause of this issue. The same as normal Transmissions and therefore...
Although depressing the brake pedal (and activating the switch controlling the brake light circuit) "potentially" leads to activation of the ABS system, it is not necessarily the case that an ABS malfunction would itself cause the brake light circuit to...
Heat changes the electrical resistance, and thence operation, of electrical components. That is possibly the underlying issue. The way to diagnose this is immediately after the shut down. If the vehicle is not starting at all, once hot, a no...
Hi. This issue can be one of many things. From detonation occurring in your engine, a timing belt needing to be replaced, a faulted catalytic converter, or an issue with fuel that is in your vehicle. More information about when...
Hi There, It sounds like you may have a dirty or failing idle air control valve causing your engine idle to fluctuate and eventually stall. The idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement) is a small valve on the engine's intake system...
Hi there, thanks for writing in. Quite often when the vehicle runs out of gas, especially on electronic fuel injected vehicles, the fuel pump may not have the required pressure to deliver gasoline to the fuel rail. In most cases...
I often hear about getting an oil change then something is wrong afterwards. I can say from experience that that the oil change itself won't cause your car not to start. I explain coincidental failures by relating them to a...
Hello there, many faults can cause your 2003 Nissan Murano to crank but not start. Replacing the battery is a great first step as this is routinely the cause. Other likely faults are the starter, fuel pump, fuel filter, ignition...
If your Nissan has detected an issue with your transmission in any way, it will typically trigger a setting from the Engine Control Module (ECM) called "limp mode". Limp mode limits the transmission to only second gear, which keeps your...
The battery light and oil light will normally come on during the pre-ignition starting phase when turning the key. There may be a number of reasons as to what may cause the car not to start. Depending on whether or...
Hi Wolton. Thanks for contacting us today. In most cases, the issues with CVT transmissions is related to damaged inner seals due in large part, to excessive heat build-up - which is why your symptoms appear in heavy traffic or...
The solenoid is mounted to the front engine cover, toward the front of the engine compartment, and above the crankshaft pulley. The two codes, P0011 (https://www.yourmechanic.com/article/p0011-obd-ii-trouble-code-camshaft-position-a-timing-over-advanced-or-system-performance-bank-1-by-jay-safford) and P0021 (https://www.yourmechanic.com/article/p0021-obd-ii-trouble-code-camshaft-position-a-timing-over-advanced-or-system-performance-bank-2-by-jay-safford) signify a fault in the variable valve timing control system. Although...
Hi James. Thanks for contacting us today. Any time you replace OEM components, it is best to refer to the OEM service and repair manual. If you don't have one, I would recommend contacting a Nissan dealership and asking their...
