Volkswagen ID.4 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(9)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(9)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Volkswagen ID.4 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2022 Volkswagen ID.4ElectricService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2021 Volkswagen ID.4ElectricService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Volkswagen ID.4 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Volkswagen mechanics

Real customer reviews from Volkswagen owners like you.

Excellent Rating

(9)

Rating Summary
9
0
0
0
0
9
0
0
0
0

Richard

21 years of experience
461 reviews
Richard
21 years of experience
Volkswagen Passat L4-2.0L Turbo - Car starts and then dies Inspection - Atlanta, Georgia
Richard was on time and diagnosed the problem very quickly. I would definitely recommend him.

Cognac

20 years of experience
73 reviews
Cognac
20 years of experience
Volkswagen Beetle H4-1.2L - Car starts and then dies - Cordova, Tennessee
no

Dario

9 years of experience
58 reviews
Dario
9 years of experience
Volkswagen Jetta L4-2.0L - Car starts and then dies - Atlanta, Georgia
My VW Jetta (2000 GLS with very low miles) has been misdiagnosed by 2 auto repair shops. Dario arrived today, a VW expert, and spotted the problem right away. He proceeded to explain the repair process in detail, and answered my (many) questions with patience and expertise. I have never felt relieved after a mechanic assessment. Until today. Thanks for the excellent service Dario. (It should be noted that Dario completed his assessment even as it started to rain. Above and beyond.)

Jay

16 years of experience
40 reviews
Jay
16 years of experience
Volkswagen Passat L4-2.0L Turbo - Car starts and then dies - Boynton Beach, Florida
Very nice and easy going well experienced

Excellent Rating

(9)

Rating Summary
9
0
0
0
0
9
0
0
0
0
Number of Volkswagen Car starts and then dies Inspection services completed
99+
services done by our mechanics
TOTAL NUMBER OF EXPERT Volkswagen MECHANICS
1000+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Air Pump Filter
If your engine is running sluggishly, the Check Engine Light is on, or there is a rough idle, you may need to replace your car's air pump filter.
How Long Does an Air Spring Bag Last?
Air Air suspension systems have been in place for a long time in the trucking industry, and over the past decade, they have moved into ordinary passenger vehicles. The support to the springs is delivered by means of air spring...
How to Clean Bug Splats Off Your Car
If If you drive long enough, at some point you’re going to end up with bug splats on the front of your car. This is especially true after a long road trip or during certain times of the year when...

How do you adjust the sound on the audio system?

Your Accord’s audio system lets you adjust the level of treble, bass, mid-range and other sounds through the interface. All you need to do to customize the sound of your audio system is follow these few brief steps: Press the...

Squealing sounds when the truck is under load

Hello. Firstly, I suggest checking for vacuum leaks, the turbo piping for leaks, and the exhaust tubing that goes to the EGR valve for any cracks. Any of those conditions could cause high pitched noises. I've noticed that a few...

Could the brake servo booster that the master cylinder attaches to cause the brake pedal's excessive travel?

Hi there. Typically, when a brake booster fails, the result is a hard to push brake pedal. The pressure release you hear is engine vacuum and may be normal considering, the brake pedal travels to the floor. With no apparent...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com