Volkswagen Golf Brake Drum Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Brake Drum Replacement Service

How much does a Brake Drum Replacement cost?

On average, the cost for a Volkswagen Golf Brake Drum Replacement is $287 with $154 for parts and $133 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1991 Volkswagen GolfL4-2.0L	Service typeBrake Drum Replacement	Estimate$545.76	Shop/Dealer Price$652.21 - $935.55
2000 Volkswagen GolfV6-2.8L	Service typeBrake Drum Replacement	Estimate$569.62	Shop/Dealer Price$690.06 - $1015.32
1997 Volkswagen GolfV6-2.8L	Service typeBrake Drum Replacement	Estimate$460.78	Shop/Dealer Price$554.01 - $797.63
1995 Volkswagen GolfL4-2.0L	Service typeBrake Drum Replacement	Estimate$674.77	Shop/Dealer Price$798.08 - $1093.79
2002 Volkswagen GolfL4-1.9L Turbo Diesel	Service typeBrake Drum Replacement	Estimate$560.13	Shop/Dealer Price$679.59 - $1004.10
2000 Volkswagen GolfL4-1.8L Turbo	Service typeBrake Drum Replacement	Estimate$560.13	Shop/Dealer Price$679.56 - $1004.06
1998 Volkswagen GolfL4-2.0L	Service typeBrake Drum Replacement	Estimate$691.27	Shop/Dealer Price$814.20 - $1109.63
2010 Volkswagen GolfL4-2.0L Turbo Diesel	Service typeBrake Drum Replacement	Estimate$485.03	Shop/Dealer Price$585.64 - $855.19

Show example Volkswagen Golf Brake Drum Replacement prices

What are brake drums and how do they work?

A brake drum is a heavy, cast iron brake system part that looks like a shallow, several inches-high cylinder about 9 to 12 inches in diameter. The brake drum has a precisely machined surface all around the interior circumference, that the brake shoes make contact with when you apply the brakes, transmitting hydraulic pressure through the wheel cylinder. This forces the brake shoes outward against the interior of the brake drum, resulting in the friction that causes the car to slow. The brake drum is mounted over, and fully encloses, all of the rear brake components such as the wheel cylinder, springs and clips, brake shoes, and parking brake mechanism. The drum is commonly held to the wheel hub by the wheel and the lug nuts, but some configurations combine the drum with the wheel hub as one unit. Nowadays, a drum brake type system is only installed on the rear axle, if used at all, as 4 wheel disc type systems have become more common.

When to consider replacing brake drums:

Reduced braking effectiveness. If the brake drum is unevenly worn, scored or cracked, it will increase stopping distances. A cracked drum must be replaced outright but a worn drum can be restored on a brake lathe so long as enough metal material remains.
Pulsating brakes, pulling to one side, vibration or noise. If a brake drum is warped, is unevenly worn, or perhaps the brake shoes have worn down completely — creating metal-to-metal contact — you might detect pedal pulsation, the vehicle may pull to one side, or you might feel a vibration or hear a noise when you apply the brakes. The brake system will have to be inspected to pinpoint the exact problem.
Brake shoe replacement. Anytime the brake shoes are replaced, the drum must either be resurfaced or replaced outright. Installing new brake shoes on a used, unresurfaced drum will lead to poor results.
Loss of parking brake function. The parking brake locks the brake shoes against the brake drum. If the brake drum is cracked, the parking brake lever will pull up excessively and the car may still be able to roll. However, a more common circumstance is parking brake maladjustment or seizure of parking brake components. Repair of those problems will often require removal of the brake drum.

How do mechanics replace brake drums?

There are two options when it comes to brake drum service: outright replacement or resurfacing. In some cases, it is cheaper to replace the drum rather than refurbish it. In both cases though, the removal and installation procedure for the drum is the same.

Raise the vehicle and safely support it using steel jack stands.
Remove tire and wheel assembly.
Remove brake drum. Sometimes the brake drum has rusted to the wheel hub and removal of the drum will require a brake drum puller. In some cases, the wheel hub is integral to the brake drum, in which case the hub-bearing retaining bolt and the wheel bearing must be removed to replace the drum.
Measure the interior diameter of the machined surface in the drum with a brake drum micrometer or similar measuring tool. If sufficient metal exists to resurface the drum on a brake lathe, the mechanic will compare the cost of such restoration to the alternative: buying a new drum.
Prior to installing the resurfaced or new drum, the brake shoes, springs, wheel cylinder, parking brake mechanism, and backing plate are all inspected. All worn parts should be replaced. Generally, if drums have been replaced or resurfaced, new brake shoes should be installed. The worn shoes will cause irregular wear in the brake drum and reduce braking effectiveness.
The shoes are adjusted and the drum is installed. The wheel and tire assembly are installed and torqued in the proper sequence and the car is road tested to check the operation of the brakes.

Is it safe to drive with a brake drum problem?

No. Should there be a deficiency with the brake drums, stopping distances will not be as short as possible. In a panic stop, stopping just five or ten feet shorter could be the difference between no collision and a collision. Any deficiency in a vehicle’s braking system is a cause for concern and a potential safety issue. Have the brake drums inspected at your earliest convenience to determine if a problem exists and find out what must be done to fix it.

When replacing brake drums keep in mind:

With few exceptions, brake work on one end of an axle should be performed on both ends of the axle. Should a brake drum on one end of a front or rear axle be serviced, or brake shoes on one end are serviced, both sides of the axle should receive the same service. This helps to avoid problems, such as pulling, vibration, and so forth, once the vehicle is returned for use.
Brake drum systems use very powerful springs to keep the brake shoes in position. These springs are exposed to extreme heat. It is best practice to replace all springs whenever new shoes are installed. Should a spring unexpectedly break in the brake drum assembly, a mispositioned brake shoe could cause the brakes to grab and lock, which would pose a safety issue.
If the wheel hub and bearing are integral to the brake drum on your car, the mechanic may recommend replacement of the grease in the wheel bearings and inspection of the wheel bearings.
Since the arc of the brake shoes will not perfectly match with the arc of the drum when new, expect a bed-in period before maximum braking efficiency is achieved.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Volkswagen mechanics

Real customer reviews from Volkswagen owners like you.

Excellent Rating

(252)

Rating Summary

238

7

3

0

4

238

7

3

0

4

SEE REVIEWS NEAR ME

Dave

23 years of experience

303 reviews

Dave

23 years of experience

by Radostina

Volkswagen Golf L4-2.0L - Check Engine Light is on - Cupertino, California

Ivan

12 years of experience

19 reviews

Ivan

12 years of experience

by Ricardo

Volkswagen Golf L4-2.0L - Brake Pads Replacement (Front) - Van Nuys, California

Very friendly, honest and professional

Deane

11 years of experience

340 reviews

Deane

11 years of experience

by Lisa

Volkswagen Golf L4-1.8L Turbo - Washer fluid does not spray onto windshield - Solana Beach, California

Deane was awesome! I can't say enough good things. Super resourceful, smart, fun to talk to...fixed my car right up. Just an all around great human being. Highest recommendation.

Whitney

39 years of experience

783 reviews

Request Whitney

Whitney

39 years of experience

Request Whitney

by Sam

Volkswagen Golf V6-2.8L - Pre-purchase Car Inspection - Redwood City, California

An all around solid mechanic and person.

Excellent Rating

(252)

Rating Summary

238

7

3

0

4

238

7

3

0

4

SEE REVIEWS NEAR ME

Recent articles & questions

Top 10 Scenic Drives in Delaware

From tax-free shopping at beach boutiques to sprawling mansion grounds, there’s more to Delaware than initially meets the eye. The state is full of hidden treasures to unlock with the investment of just a little time, and its history from...

Delaware Speed Limits, Laws, and Fines

Following Following is an overview of the laws, limits, and fines as they relate to speeding traffic violations in the state of Delaware. Speed limits in Delaware 65 mph: I-495, entire toll road stretch of Delaware Route 1, and I-95...

Veteran and Military Driver Laws and Benefits in Rhode Island

There There are a number of specific rules and laws that apply to active military members in the state of Rhode Island, as well as quite a few benefits that apply to both current servicemembers and veterans. License and registration...

How do you adjust the instrument light brightness?

Your dash lights can be set to almost any level of brightness you want. Most drivers find it convenient to set the dash/instrument panel lights to a brighter setting during early evening and then a low brightness once night has...

My car will not accelerate past 20 mph. No check engine is on and I just replaced ignition coil 06 Kia Rio base

This issue could be occurring for several different reasons. Firstly, it is possible that there could be an issue with the spark plugs and wires. On a four cylinder engine only one or two bad plugs can cause the engine...

my99 3.1 gm idles up and down replaced the iac and egr what gives then dies but driving its ok

You most likely have a intake vacuum leak. You should have the computer scanned first to make sure you do not have a TPS problem or other sensor issue. Pinch off the vacuum line to the brake booster to see...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com