Volkswagen EuroVan Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(41)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(41)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Volkswagen EuroVan Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1993 Volkswagen EuroVanL5-2.5LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1996 Volkswagen EuroVanL5-2.4L DieselService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1999 Volkswagen EuroVanV6-2.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1995 Volkswagen EuroVanL5-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1997 Volkswagen EuroVanL5-2.4L DieselService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2000 Volkswagen EuroVanV6-2.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1995 Volkswagen EuroVanL5-2.4L DieselService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2002 Volkswagen EuroVanV6-2.8LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Volkswagen EuroVan Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Volkswagen mechanics

Real customer reviews from Volkswagen owners like you.

Excellent Rating

(41)

Rating Summary
35
2
0
1
3
35
2
0
1
3

Paul

25 years of experience
261 reviews
Paul
25 years of experience
Volkswagen EuroVan L5-2.5L - Car is not starting - Las Vegas, Nevada
Paul arrived on time, was very professional and courteous. He was very knowledgeable and found that our problem was probably just an unstable battery. We will call Paul if we need any future help.

Lucas

21 years of experience
887 reviews
Lucas
21 years of experience
Volkswagen EuroVan V6-2.8L - Oil Change - La Crescenta, California
Lucas arrived within the one hour window that was specified. He was friendly and seemed very knowledgeable. Although he performed a simple oil change, he was able to answer additional questions I had and tell me what things I needed to keep an eye on in the future. When he was done and starting to clean up, he noticed that part of the old oil filter was missing. He didn't hesitate to immediately put the van back up on the jack to inspect the oil filter housing, and found the missing piece from the badly worn out old oil filter! I appreciated his thoroughness and attention to detail.

Michael

21 years of experience
80 reviews
Michael
21 years of experience
Volkswagen EuroVan L5-2.5L - Axle / CV Shaft Assembly Replacement (Driver Side Front, Passenger Side Front) - Lakewood, Washington
Great mechanic, showed up and got the job done with no hiccups.

Krystal

17 years of experience
106 reviews
Krystal
17 years of experience
Volkswagen EuroVan V6-2.8L - Transmission Fluid Service - Thornton, Illinois
She was a very professional made sure that everything was right before she left and I was happy with the work before she left she's very professional person

Excellent Rating

(41)

Rating Summary
35
2
0
1
3
35
2
0
1
3
Number of Volkswagen EuroVan services completed
451+
services done by our mechanics
TOTAL NUMBER OF EXPERT Volkswagen MECHANICS
1000+
experts on our platform

Recent articles & questions

How to Buy a Good Quality Exhaust Gas Recirculation (EGR) Valve
The The exhaust gas recirculation valve (EGR valve) serves to dramatically reduce the emissions that are key contributors to pollution in the air. While EGR systems were not routinely added to engines until 1973, nearly all engines produced or on...
P0771 OBD-II Trouble Code: Shift Solenoid E Performance or Stuck Off
P0771 code means there is an detected problem within shift solenoid "E" often due too low/dirty transmission fluid or shorted wiring.
P0914 OBD-II Trouble Code: Gear Shift Position Circuit
P0914 means there is an issue with the gear shift position circuit, likely due to damaged or faulty wiring, connectors, or electrical components.

Car clicking when starting

Hi there. This sounds to me as like an issue in your anti-theft system. When your vehicle has its battery changed, the power is reset. This commonly triggers the anti-theft system which tell your computer to lock up. Have a...

Will a purge solenoid eat up gas

If the he purge valve is open all the time it may cause the fuel tank to go into a vacuum and cause the gas to vaporize more than it should. You should not see very much loss of fuel...

Only runs full throttle

Measure engine compression. Check intake vacuum to get an indirect indication of whether valves are sticking or not. Check base ignition timing and advance function and, finally, look at secondary firing patterns on an oscilloscope to determine if the issue...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com