Toyota Sequoia Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(297)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(297)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Toyota Sequoia Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2019 Toyota SequoiaV8-5.7LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2006 Toyota SequoiaV8-4.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2015 Toyota SequoiaV8-5.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2017 Toyota SequoiaV8-5.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2004 Toyota SequoiaV8-4.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2011 Toyota SequoiaV8-5.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2016 Toyota SequoiaV8-5.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2009 Toyota SequoiaV8-5.7LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Toyota Sequoia Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(297)

Rating Summary
282
5
3
1
6
282
5
3
1
6

Mathew

6 years of experience
54 reviews
Mathew
6 years of experience
Toyota Sequoia V8-4.7L - Car starts and then dies Inspection - Philadelphia, Pennsylvania
Matt really knows his stuff, not only he was able to find the problem but also fixed it! I will definitely contact him in the future for any other car-related stuff. Thank you!

Dan

39 years of experience
975 reviews
Dan
39 years of experience
Toyota Sequoia V8-5.7L - Brake System Flush - Duluth, Georgia
Always a pleasure.

Jeffrey

27 years of experience
870 reviews
Jeffrey
27 years of experience
Toyota Sequoia V8-4.7L - Brake Rotor/Disc Replacement (Rear) - Waxhaw, North Carolina
Jeffrey did a great job!!

Raul

34 years of experience
285 reviews
Raul
34 years of experience
Toyota Sequoia V8-4.7L - Replace back hatchback latch - Fremont, California
I have had Raul service my vehicle twice. He is very professional to work with. He is top notch customer service oriented and very personable which is important to me. I have no problem referring Raul to others and plan to continue to have Raul service my vehicle in the future.

Excellent Rating

(297)

Rating Summary
282
5
3
1
6
282
5
3
1
6
Number of Toyota Sequoia services completed
3267+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

How to Break in Brake Pads
Having new brake pads and rotors installed happens on a regular basis. Once those brake pads and rotors are mounted, it is...
How to Get a Used Engine
The engine (https://www.yourmechanic.com/article/how-a-modern-engine-works) under the hood is the most important component of a vehicle. Without the engine, your car cannot run and is of little value to you. If you have been in an accident, or neglected your engine to...
How to Replace a Radiator Fan Motor on Most Cars
The fan motor on the radiator fails when the engine overheats and the fan does not activate. This means that the coolant cannot cool the engine well.

Car vibrating when accelerating

Depending on the vibration, this can be caused by broken engine mounts. The mounts are meant to absorb the vibration of the engine as it runs. When mounts break, the rubber that absorbs the vibrations can break off completely and...

P0755 & P0700 error codes

The problem with buying used tires and not having them balanced is the potential problems they can cause. Most transmissions - or more specifically, the Powertrain Control Module (PCM) which controls the transmission and drive line - contain incredibly tight...

Skoda/VW Intermittent power loss and RPM shooting high - If clutch then how its coming up Just after Car Servicing

If the symptoms you describe started literally the instant you drove away from the repair facility (as opposed to commencing even a day later) then the likelihood is an electrical connector, or vacuum line, was disturbed during the service or...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com