Toyota MR2 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(28)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(28)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Toyota MR2 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1994 Toyota MR2L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1987 Toyota MR2L4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1988 Toyota MR2L4-1.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1993 Toyota MR2L4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1995 Toyota MR2L4-2.2LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1991 Toyota MR2L4-2.0L TurboService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1988 Toyota MR2L4-1.6L TurboService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1991 Toyota MR2L4-2.2LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Toyota MR2 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(28)

Rating Summary
26
1
0
1
0
26
1
0
1
0

Raymond

15 years of experience
54 reviews
Raymond
15 years of experience
Toyota MR2 L4-2.0L Turbo - Car is not starting - San Antonio, Texas
Excellent service!

Cesar

9 years of experience
292 reviews
Cesar
9 years of experience
Toyota MR2 L4-2.2L - Oil Change - Seattle, Washington
Really good mechanic very helpful and knowledgeable highly recommended!

Attila

19 years of experience
917 reviews
Attila
19 years of experience
Toyota MR2 L4-2.2L - Adjust Ignition Timing - Newark, New Jersey
Attila was a great help and helped ID a larger issue with my MR2, thanks for your help !!!

Raymond

36 years of experience
63 reviews
Raymond
36 years of experience
Toyota MR2 L4-1.6L - Clutch is not releasing - Federal Way, Washington
Very nice guy.

Excellent Rating

(28)

Rating Summary
26
1
0
1
0
26
1
0
1
0
Number of Toyota MR2 services completed
308+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

Symptoms of a Bad or Failing Tie Rod End
Common signs of a faulty tie rod end include a front end alignment that is off, a shaky or loose steering wheel, and uneven or excessive tire wear.
How to Renew Your Car Registration in Iowa
Owning Owning a car comes with a lot of responsibility. In order to keep your car in compliance in the state of Iowa, you will have to register it with the Department of Transportation. This is not the end of...
How to Get Smog Technician Certified in Tennessee
Automotive technician jobs include smog certified emissions inspectors. In Tennessee, Envirotest or Opus are the places to apply for an inspector job.

Car shakes when I'm idel. What could be wrong and how much to fix it?

Based on your symptoms of rough idle and a check engine light, I would recommend a check engine light inspection. This will help to determine the exact cause of the rough running and check engine light. Consider YourMechanic as check...

Check engine light on. Code read as p0420. Bank 1 below threshold for predetermined amount of time. What 02 sensor up or lower?

Hi there. When the oxygen sensors have readings that are similar to each other, it is an indication that the catalytic converter is not working as intended. If the voltage of the downstream oxygen sensor decreases, and begins to fluctuate...

2011 dodge charger rt turns over ,but wont crank

This may be related to many different possibilities, some of which may be related to a lack of spark or possibly timing issues and some of which may be related to a fuel delivery problem or a combination of both....

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com