Toyota Echo Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(99)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(99)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Toyota Echo Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2005 Toyota EchoL4-1.5LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2003 Toyota EchoL4-1.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2004 Toyota EchoL4-1.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2001 Toyota EchoL4-1.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2000 Toyota EchoL4-1.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2002 Toyota EchoL4-1.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Toyota Echo Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(99)

Rating Summary
96
2
0
0
1
96
2
0
0
1

Dellano

18 years of experience
513 reviews
Dellano
18 years of experience
Toyota Echo L4-1.5L - Spark Plug Replacement - Hyattsville, Maryland
Friendly and communicative.

Anthony

17 years of experience
39 reviews
Anthony
17 years of experience
Toyota Echo L4-1.5L - Oil Change - Antioch, California
Arrived early (big plus) Friendly, very easy to talk to, answered all my questions ( I had a lot of them), was done in a jiff. Thank You Anthony.

William

33 years of experience
69 reviews
William
33 years of experience
Toyota Echo L4-1.5L - Pressure Test Radiator Cap - Temecula, California
Seemed like he knew his stuff

Jay

37 years of experience
948 reviews
Jay
37 years of experience
Toyota Echo L4-1.5L - Engine Variable Valve Timing (VVT) Oil Control Valve - Cabazon, California
Jay was not only knowledgeable, he explained everything in an easy to understand manner. I would definitely recommend Jay to friends and family.

Excellent Rating

(99)

Rating Summary
96
2
0
0
1
96
2
0
0
1
Number of Toyota Echo services completed
1089+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

3 Essential Things to Know About your Car’s GPS
Thanks Thanks to technology, navigation has become quite a bit easier. Instead of relying on maps and directions from friendly gas station attendants, most people are using GPS, global positioning satellite systems, to help them find their way around the...
P0269 OBD-II Trouble Code: Cylinder Number 3 Contribution/Balance Fault
P0269 P0269 code definition Cylinder Number 3 Contribution/Balance Fault What the P0269 code means P0269 is an OBD-II diagnostic trouble code (https://www.yourmechanic.com/article/what-is-the-on-board-diagnostics-obd-system) which indicates that the engine control module (ECM) (https://www.yourmechanic.com/article/what-is-a-vehicle-s-electrical-control-unit) detected the cylinder number 3 having low contribution to...
Signs Your Car Needs an Oil Change
Oil changes keep your car engine running smoothly. Rough idling, slow acceleration, and engine noises mean you need to replace your car oil.

vibrations and steering wheel shimmy/shake between 45-60 MPH.

Hey there, thanks for writing in. You may want to have the CV (constant velocity) joints and axles (https://www.yourmechanic.com/services/axle-cv-shaft-assembly-replacement) inspected. When these wear out or become damaged in any way, this can cause a vibrating problem at both high speeds...

I have a Shogun 3.2 did. The mut scanner from a friend reveals a fault code 35 and says the engine rpm at 3000 and 330 n/m.

Hi there. The fault code 35 reveals that the O2 sensor (https://www.yourmechanic.com/services/oxygen-sensor-replacement) bank one (upstream sensor) has picked up an issue with the emission quality of the exhaust. This means that the engine could be lean or rich in fuel...

2008 Buick Lucerne my car cranks but won’t turn over I replace fuel pump, relays,battery.

Many keys that have a chip in them must be programmed to the vehicle. I would recommend visiting your local dealership to get your key program to the vehicle. Once this has been done the vehicle should start right away....

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com