Toyota Camry Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(3,818)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(3,818)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Toyota Camry Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2002 Toyota CamryV6-3.0LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2000 Toyota CamryV6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2003 Toyota CamryV6-3.0LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2019 Toyota CamryL4-2.5L HybridService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2016 Toyota CamryV6-3.5LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1995 Toyota CamryL4-2.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1994 Toyota CamryV6-3.0LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2011 Toyota CamryV6-3.5LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Toyota Camry Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Toyota mechanics

Real customer reviews from Toyota owners like you.

Excellent Rating

(3,818)

Rating Summary
3,552
160
27
19
60
3,552
160
27
19
60

Ben

41 years of experience
1410 reviews
Ben
41 years of experience
Toyota Camry L4-2.4L - Oil Pan Gasket - Houston, Texas
The requested repairs were completed with complete satisfaction.

Jequan

7 years of experience
74 reviews
Jequan
7 years of experience
Toyota Camry L4-2.4L - Car is not starting - Durham, North Carolina
Very polite and professional. I would highly recommend Jequan.

Kevin

33 years of experience
234 reviews
Kevin
33 years of experience
Toyota Camry L4-2.4L - 75 Point Safety Inspection - Torrance, California

Breck

20 years of experience
681 reviews
Breck
20 years of experience
Toyota Camry L4-2.4L - Car is overheating - Humble, Texas
Great service

Excellent Rating

(3,818)

Rating Summary
3,552
160
27
19
60
3,552
160
27
19
60
Number of Toyota Camry services completed
41998+
services done by our mechanics
TOTAL NUMBER OF EXPERT Toyota MECHANICS
1600+
experts on our platform

Recent articles & questions

How to Tell If Your Car Switches Are Dying
Since Since every part of your car is controlled or operated by a switch in some fashion, it is to be expected that the switch will eventually fail. Some of the most commonly used switches in your car are: Power...
How to Get a Vermont Driver's Permit
The The state of Vermont uses a graduated driver’s license program which requires all new drivers to begin driving with a learner’s permit, in order to practice safe driving under supervision before getting their full driver’s license. To receive the...
P2628 OBD-II Trouble Code: O2 Sensor Pumping Current Trim Circuit / High Bank 1 Sensor 1
P2628 P2628 Code Definition The P2628 code is a generic powertrain code related to computer circuit output issues. This code appears when the oxygen sensor pumping current trim circuit for engine bank 1 has sent the engine control module (ECM)...

2003 Dodge Dakota still won't start after replacing battery

The starting system is rather simple. The battery, the starter, and the ignition are the only major components. There are a few sensors related to the system that may need to be checked. The first thing you should do is...

My right turn signal was dimming the dash lights now the whole turn signal bar will not work. Headlights are on will not turn off

Hi there. Typically the root source of this problem is the control module that supplies power and activates electrical accessories, like the turn signals, brake lights and such. It can be either an exposed wire creating an electrical drain or...

What is The Cost of Parts to Replace a Bad Exhaust Intake Valve on a 1995 GMC Sierra? How Long does it take to complete job?

Hi M.H. Thanks for contacting us tonight. Unfortunately, this is a service that our mobile mechanics are unable to offer. This type of job should be completed at a local engine shop, as removing valves will require special tools in...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com