Saturn SW1 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(6)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(6)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Saturn SW1 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1997 Saturn SW1L4-1.9LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1994 Saturn SW1L4-1.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1996 Saturn SW1L4-1.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1995 Saturn SW1L4-1.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1999 Saturn SW1L4-1.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1998 Saturn SW1L4-1.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1993 Saturn SW1L4-1.9LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
Show example Saturn SW1 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Saturn mechanics

Real customer reviews from Saturn owners like you.

Excellent Rating

(6)

Rating Summary
5
1
0
0
0
5
1
0
0
0

Robert

31 years of experience
641 reviews
Robert
31 years of experience
Saturn SW1 L4-1.9L - Alternator - Santa Clara, California
Excellent. He didn't stop working on it until my car was running again. Highly recommended.

Ejnar

29 years of experience
107 reviews
Ejnar
29 years of experience
Saturn SW1 L4-1.9L - Shift Selector Cable - Hayward, California
I was very, very pleased with the work Ejnar did on my car. He is very knowledgeable, very polite and funny. I would definitely recommend him to any of my friends who needs a mechanic. Great job Ejnar. Thanks so much for getting me back on the road.

Dave

23 years of experience
303 reviews
Dave
23 years of experience
Saturn SW1 L4-1.9L - Oil Change - Santa Cruz, California
Dave is awesome. I had a quote from a local shop here that botched a previous repair job. Dave saved me 534.94$ today by figuring out that it was only the oil filter that had to be replaced.

Chris

20 years of experience
448 reviews
Chris
20 years of experience
Saturn SW1 L4-1.9L - Starter - Beaverton, Oregon
Very Quick and Knowledgeable of what was required

Excellent Rating

(6)

Rating Summary
5
1
0
0
0
5
1
0
0
0
Number of Saturn SW1 services completed
66+
services done by our mechanics
TOTAL NUMBER OF EXPERT Saturn MECHANICS
700+
experts on our platform

Recent articles & questions

Is it Safe to Drive With a Faulty Knock Sensor?
Symptoms of a bad or failing engine knock sensor include slow acceleration, reduced fuel economy, and the Check Engine Light turning on.
Eco-Friendly Auto Tips
Driving Driving a car is the most convenient ways to get around in today's world. The auto represents instant on-demand mobility, and with this comes a great deal of personal freedom. The drawback is that traditional cars, which represent the...
P0649 OBD-II Trouble Code: Speed Control Lamp Control Circuit
P0649 means the PCM has detected a problem with the speed control lamp circuit due to a faulty speed control lamp bulb or circuit, wiring issues.

How do I operate the Speed Dependent wipers?

If your car is equipped with Speed Dependent wipers (these are optional equipment), you have the ability to turn them to intermittent, and then let them be – they’ll automatically speed up with your vehicle, and then slow down when...

Where is temperature sensor

The engine coolant temperature sensor should be located on the radiator hose fitting on the front of the engine. The connector is locked in place by a clip lock on the connector housing that needs to be depressed at the...

Electricity gauge reading low voltage. Just charged my battery and replaced alternator in April. Connections look good.

Hello - the first thing to check is the electrical system voltage with the engine running at a fast idle - which should be 13 volts or above. Check this with a known good voltage meter - auto gauges are...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com