Ram ProMaster 3500 Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Ram ProMaster 3500 Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2017 Ram ProMaster 3500L4-3.0L Turbo DieselService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2018 Ram ProMaster 3500L4-3.0L Turbo DieselService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2020 Ram ProMaster 3500V6-3.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2019 Ram ProMaster 3500V6-3.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2015 Ram ProMaster 3500V6-3.6LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2016 Ram ProMaster 3500L4-3.0L Turbo DieselService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2015 Ram ProMaster 3500L4-3.0L Turbo DieselService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2016 Ram ProMaster 3500V6-3.6LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Ram ProMaster 3500 Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Ram mechanics

Real customer reviews from Ram owners like you.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0

Andrew

15 years of experience
510 reviews
Andrew
15 years of experience
Ram ProMaster 3500 V6-3.6L - Oil Change - La Center, Washington
Good job,

Daniel

11 years of experience
228 reviews
Daniel
11 years of experience
Ram ProMaster 3500 L4-3.0L Turbo Diesel - Clunking or knocking noise from wheels Inspection - Chicago, Illinois
Very kind and honest.

Steve

15 years of experience
150 reviews
Steve
15 years of experience
Ram ProMaster 3500 V6-3.6L - Serpentine/Drive Belt Replacement - Glen Ridge, New Jersey
Steve was prompt and knowledgeable. I was impressed by his professionalism and ability to get the work done in a tight spot where the vehicle was parked.

Stephen

32 years of experience
179 reviews
Stephen
32 years of experience
Ram ProMaster 3500 L4-3.0L Turbo Diesel - Car does not move when I step on the gas pedal Inspection - Denver, Colorado
arrived on time and was very complete

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0
Number of Ram ProMaster 3500 services completed
55+
services done by our mechanics
TOTAL NUMBER OF EXPERT Ram MECHANICS
300+
experts on our platform

Recent articles & questions

How Long Does a Brake Master Cylinder Last?
The The fluid that flows through the braking system in your car is what helps to provide the pressure needed to stop a car. Without the proper amount of brake fluid in your car, it will be nearly impossible to...
How to Replace Your Brake Light Switch
The brake lights of your car are controlled by switches connected to the brake pedal underneath the steering wheel. These switches are...
A Guide to Tire Safety
When When sitting behind the wheel of a car, there are two things that most drivers want: to reach their destination, and to do so as safely as possible. This means having a car that is in good condition, and...

Tensioner needs replacing

Hi. The belt tensioner pulley may need to be replaced if it is chirping. The chirping noise comes from the bearing inside the pulley that is worn out. It is typical for them to be replaced along with the serpentine...

My truck struggles to start and stay running

This sounds like a fuel pump that is weak to start the vehicle and then stops pumping after ten minutes when it heats up. Have the fuel pressure checked to see if it is holding pressure and keeps pressure when...

New battery and starter but my 2001 Nissan Xterra still will not start what could be the problem

Hi there. Typically when you hear a click sound when you turn the key, and the battery and starter are new, it's due to a faulty ignition or starter relay. I would check both relays and also fuses first, as...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com