Porsche Taycan Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(762)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(762)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Porsche Taycan Car starts and then dies Inspection is $146 with $0 for parts and $146 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2021 Porsche TaycanElectricService typeCar starts and then dies InspectionEstimate$155.00Shop/Dealer Price$158.60 - $161.30
2023 Porsche TaycanElectricService typeCar starts and then dies InspectionEstimate$145.99Shop/Dealer Price$147.82 - $149.20
2022 Porsche TaycanElectricService typeCar starts and then dies InspectionEstimate$145.99Shop/Dealer Price$147.85 - $149.24
2020 Porsche TaycanElectricService typeCar starts and then dies InspectionEstimate$145.99Shop/Dealer Price$149.32 - $151.82
2024 Porsche TaycanElectricService typeCar starts and then dies InspectionEstimate$145.99Shop/Dealer Price$147.85 - $149.24
Show example Porsche Taycan Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Porsche mechanics

Real customer reviews from Porsche owners like you.

Excellent Rating

(762)

Rating Summary
705
29
4
5
19
705
29
4
5
19

Nazareth

28 years of experience
345 reviews
Nazareth
28 years of experience
Porsche Boxster H6-2.7L - Oil Change - Monterey Park, California
Great Experience with Mr Nazareths

Theodore

17 years of experience
1794 reviews
Theodore
17 years of experience
Porsche Carrera H4-2.0L - Oil Change - Sammamish, Washington
Theodore is great and always does a great job.

Mauricio

41 years of experience
85 reviews
Mauricio
41 years of experience
Porsche 911 H6-2.7L - Brake Hose Replacement (Driver Side Front, Passenger Side Front, Driver Side Rear, Passenger Side Rear) - Burbank, California
Very satisfied with service

Alex

24 years of experience
464 reviews
Alex
24 years of experience
Porsche Boxster H6-2.9L - Car Battery Replacement - Coppell, Texas
Alex showed up on time, was very friendly, and did the service quickly.

Excellent Rating

(762)

Rating Summary
705
29
4
5
19
705
29
4
5
19
Number of Porsche services completed
8382+
services done by our mechanics
TOTAL NUMBER OF EXPERT Porsche MECHANICS
300+
experts on our platform

Recent articles & questions

How Long Does a Strut Assembly Last?
Most Most modern cars on the road today use a combination of shocks and struts in the suspension system. Struts are used on the rear, while each front wheel is equipped with a strut assembly. Struts and shocks are pretty...
How to Buy a Personalized License Plate in South Dakota
A A personalized license plate (https://www.yourmechanic.com/article/how-to-find-out-which-license-plates-are-available-in-your-state-by-brady-klopfer) is one of the best ways to add customization to a vehicle. With a personalized license plate, you can share a sentiment on the front and back of your car. You can use a...
How to Replace a Clutch Cable
Clutch cables can wear out from age and clutch overuse. The location and build of your clutch cable will depend on the make and model of the car.

Odometer has lines, won't start unless I put fuel in the intake. The fuel pump keeps running and doesn't shut off? Seems like the truck wants to start.

Hi there. From the description you have provided, you've replaced the fuel pressure regulator, the fuel pump never shuts off and puts fuel in the throttle body, it runs until the fuel is gone, and the odometer has lines instead...

My Mini Pajero AC compressor is not working

Hey there. If the motor appears to be running, but is not providing compressed air, then this is a sign that the reed valves or the piston rings are worn out. If the motor is not running, there may be...

I'm trying to replace the engine coolant temp sensor on my 2007 ford fusion sel 3.0l v6. How do I install it? It doesn't seem to b

The sensor is held in place by a spring steel clip. Normally, pliers are needed to pry the retaining clip out. The new sensor should seat square to the bore in the cylinder head. If the sensor is sitting square...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com