Pontiac Sunbird Water Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(5)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(5)

Water Pump Replacement Service

How much does a Water Pump Replacement cost?

On average, the cost for a Pontiac Sunbird Water Pump Replacement is $242 with $102 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1992 Pontiac SunbirdV6-3.1LService typeWater Pump ReplacementEstimate$384.02Shop/Dealer Price$444.88 - $619.34
1993 Pontiac SunbirdV6-3.1LService typeWater Pump ReplacementEstimate$375.01Shop/Dealer Price$434.10 - $607.24
1990 Pontiac SunbirdL4-2.0L TurboService typeWater Pump ReplacementEstimate$1111.20Shop/Dealer Price$1257.38 - $1680.01
1991 Pontiac SunbirdV6-3.1LService typeWater Pump ReplacementEstimate$375.01Shop/Dealer Price$434.12 - $607.28
1993 Pontiac SunbirdL4-2.0LService typeWater Pump ReplacementEstimate$1009.01Shop/Dealer Price$1158.45 - $1583.52
1992 Pontiac SunbirdL4-2.0LService typeWater Pump ReplacementEstimate$1111.20Shop/Dealer Price$1257.91 - $1680.93
1994 Pontiac SunbirdL4-2.0LService typeWater Pump ReplacementEstimate$1067.41Shop/Dealer Price$1213.07 - $1635.32
1990 Pontiac SunbirdL4-2.0LService typeWater Pump ReplacementEstimate$1111.20Shop/Dealer Price$1257.37 - $1680.00
Show example Pontiac Sunbird Water Pump Replacement prices

What is a water pump and how does it work?

The water pump is a belt or chain-driven engine accessory bolted to the engine above the crankshaft pulley. The pump housing has an impeller that circulates engine coolant through the cooling system passageways in the engine block and cylinder head, on to the radiator, where the coolant temperature is reduced. . The lower temperature coolant then flows back to the water inlet on the engine and the water pump continues the cycle.

When to consider replacing the water pump:

  • Coolant leaks or overheating. The water pump impeller shaft is supported by a bearing. Eventually, the bearing or seal can wear and leak or damage the impeller. Many water pumps have weep holes near the pump bearing. If you see significant leakage from that weep hole, it is time to replace the pump.
  • Bearing roughness or noise. If the water pump shaft does not turn smoothly or the pump is noisy, the bearing is excessively worn. Pump replacement will be necessary.
  • Timing belt replacement. In engines where the water pump is driven by the timing belt, it is a good idea to replace the water pump at the same time the timing belt is replaced. The extensive work explains why it is always recommended to replace the water pump whenever the mechanic already has these components removed for regularly scheduled timing belt replacement.

How do mechanics replace the water pump?

  • The water pump is usually bolted to the front of the engine. The replacement procedure will vary depending on whether the pump is driven by the timing belt, the serpentine belt, or chain.
  • On a cold engine, the engine coolant is drained to a level below the water pump.
  • Components that require removing to access the water pump are removed, including the belt or chain that directly drive the pump.
  • The bolts holding the pump to the engine are removed and the pump is pulled out.
  • The gasket surface must be cleaned and the pump mounting surface inspected. A new gasket, rubber seal, or RTV sealant, as required, is installed and then the new pump. The bolts are torqued in sequence using a calibrated inch pound torque wrench.
  • For applications where the water pump is driven by the timing belt, the timing belt must be removed. Typically, this requires removal of the crankshaft pulley, timing belt covers, and timing belt tensioner. Once the new pump is installed, new coolant is added back while bleeding the cooling system of any air. The engine is then run and brought to normal operating temperature to check for leaks and ensure normal operating temperature.

Is it safe to drive with a water pump problem?

No. Should the water pump only leak a little bit, you can drive the car. However, a small leak could suddenly enlarge or the pump bearing might unexpectedly seize. Either circumstance would likely cause engine overheating. If a defective water pump causes the overheating, it is not safe to drive because of the damage to the engine.

When replacing the water pump keep in mind:

  • It is best to install a new cooling system thermostat when you install a new water pump, especially if the thermostat is old or original.
  • Completely flushing the cooling system is a good idea when you replace the water pump. Flushing can be done before or after pump replacement.
  • The rest of the cooling system should be inspected too — particularly rubber hoses, which have a limited lifetime.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Pontiac mechanics

Real customer reviews from Pontiac owners like you.

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0

Michael

41 years of experience
131 reviews
Michael
41 years of experience
Pontiac Sunbird L4-2.0L - Car is overheating - Columbus, Ohio
Michael was very professional, kind, courteous, attentive. He listened to what I had to say and helped to find the solution to the problem. Thank you, Mike, for everything you did to get me back on the road. 

Joshua

28 years of experience
709 reviews
Joshua
28 years of experience
Pontiac Sunbird L4-2.0L - Ignition key does not turn - Oakland, California
Joshua was great. He arrived early which was a plus. He quickly resolved the problem and ordered the parts. I would recommend him to everyone. As a matter of fact while he was there attending my Mom's car, I had him to look at my car as well. He was wonderful and very professional.

John

7 years of experience
35 reviews
John
7 years of experience
Pontiac Sunbird V6-3.8L - Car does not move when I step on the gas pedal Inspection - Renton, Washington
John was super awesome and honest. He showed and explained why I needed certain things and was very helpful in making a well informed decision. Highly reccomend him.

Paul

11 years of experience
38 reviews
Paul
11 years of experience
Pontiac Sunbird L4-2.0L - Ignition Lock Assembly - Austin, Texas

Excellent Rating

(5)

Rating Summary
5
0
0
0
0
5
0
0
0
0
Number of Pontiac Sunbird services completed
55+
services done by our mechanics
TOTAL NUMBER OF EXPERT Pontiac MECHANICS
800+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 BMW 1-Series
The The 2012 BMW 1-Series, which includes both the 128i and the 135i in both a coupe and convertible options, provides the perfect combination of power, performance and luxury. Designed with a focus on thrilling acceleration and a smooth, elegant...
What Does the Brake Pad Wear Indicator Warning Light Mean?
The brake pad wear indicator warning light comes on when the brake pads are detected to be too thin.
How Long Does a Brake Light Bulb Last?
Having Having properly working lights on your car is important when driving on busy roadways. Making sure that the other motorists see you and what you are doing can help to eliminate the risk of an accident. Most of the...

White smoke coming out from exhaust, what can that be?

Hello, thanks for writing in. I'd be happy to help. White smoke from the exhaust can be caused by a few things. First off, keep in mind that white smoke coming from the tailpipe after a cold start can be...

Rough Idle when first started or when wet

Hello, I sounds like you may have a dirty or faulty idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement). As you know, this monitors and reads the air intake as it enters the engine prior to being mixed with fuel while making adjustments...

How do I fill the cooling system in my 1994 C220 Mercedes

To properly fill your cooling system, you need to start with the engine cold. With the engine off, fill the radiator slowly until the level is about 1"below the neck. Leave the cap off and with the car in park...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com