Pontiac GTO Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(32)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(32)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Pontiac GTO Car Battery Replacement is $296 with $156 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2006 Pontiac GTOV8-6.0LService typeCar Battery ReplacementEstimate$467.32Shop/Dealer Price$549.00 - $785.94
2004 Pontiac GTOV8-5.7LService typeCar Battery ReplacementEstimate$458.31Shop/Dealer Price$538.22 - $773.84
2005 Pontiac GTOV8-6.0LService typeCar Battery ReplacementEstimate$458.31Shop/Dealer Price$538.25 - $773.88
Show example Pontiac GTO Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Pontiac mechanics

Real customer reviews from Pontiac owners like you.

Excellent Rating

(32)

Rating Summary
31
0
1
0
0
31
0
1
0
0

Joseph

16 years of experience
52 reviews
Joseph
16 years of experience
GTO 1969 - Battery - Boca Raton, FL
Joseph — did great!! Thank you

Andrew

12 years of experience
83 reviews
Andrew
12 years of experience
GTO 2004 - Clutch Master Cylinder - Sumner, WA
On time. Knowledgeable of my car. Pleasnt and cleaned up the mess.

Anderson

25 years of experience
90 reviews
Anderson
25 years of experience
GTO 2006 - Starter - Flushing, NY
Polite and punctual. Highly recommended.

Walter

43 years of experience
238 reviews
Walter
43 years of experience
GTO 1969 - Car is hard to shift - Claremore, OK
A great mechanic! Polite and professional. He showed up on time and fixed the problem right away. I highly recommend this gentleman to anyone needing a knowledgeable mechanic.

Excellent Rating

(32)

Rating Summary
31
0
1
0
0
31
0
1
0
0
Number of Pontiac GTO services completed
352+
services done by our mechanics
TOTAL NUMBER OF EXPERT Pontiac MECHANICS
800+
experts on our platform

Recent articles & questions

The Best Used Cars to Buy If You Live in the Country
Living Living in the country is a whole different way of living. You deal with rough and uneven roads, mud, snow, rain, and ice and you need a vehicle that can stand up to these kinds of conditions with ease....
P0733 OBD-II Trouble Code: Gear 3 Incorrect Ratio
P0733 Code Definition Gear 3 incorrect ratio is the technical definition of the P0733 trouble code What the P0733 code means The...
How to Get Smog Technician Certified in Massachusetts
Automotive technician jobs include smog certified emissions inspectors. In Massachusetts, you must be hired and trained by Parsons to become one.

Fuel gauge is not accurate, what can I do?

The fuel gauge system on your vehicle is comprised of two sensors in the fuel tank and the gauge on the dash. The system can be tested using a scan tool for codes pertaining to the fuel system. The most...

Car has a hard time starting

Hello! On your particular vehicle, the hard start condition is commonly caused by a faulty fuel pump relay, fuel pump, or fuel filter, so I suggest checking the fuel pressure to determine if there is a problem with the fuel...

How do you scan the GEM module in a 1996 Ford Explorer?

The GEM module can only be scanned using a scanner capable of accessing the GEM module through the OBD2 data link. The scanners that the Ford dealer uses can access the module. There are aftermarket scanners on the market than...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com