Nissan Versa Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(662)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(662)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Nissan Versa Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2014 Nissan VersaL4-1.6LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2017 Nissan VersaL4-1.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2015 Nissan VersaL4-1.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2019 Nissan VersaL4-1.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2011 Nissan VersaL4-1.8LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2010 Nissan VersaL4-1.6LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2016 Nissan VersaL4-1.6LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2022 Nissan VersaL4-1.6LService typeReduced Power light is on InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Nissan Versa Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Nissan mechanics

Real customer reviews from Nissan owners like you.

Excellent Rating

(662)

Rating Summary
629
17
4
5
7
629
17
4
5
7

Joe

15 years of experience
453 reviews
Joe
15 years of experience
Nissan Versa L4-1.8L - Exterior Door Handle Replacement (Driver Side Front) - Nashville, Tennessee
Very professional and respectful of my time and money. Made sure I understood what the process was and asked if I had any questions. Will be calling on him again.

Michael

21 years of experience
80 reviews
Michael
21 years of experience
Nissan Versa L4-1.6L - Oil Change - Lakewood, Washington
He was polite, fast, competent, efficient, and thorough. I highly recommend him to others.

Charles

34 years of experience
342 reviews
Charles
34 years of experience
Nissan Versa L4-1.6L - Catalytic Converter - Austin, Texas
Charles was very fast and efficient.

Ralph

38 years of experience
187 reviews
Ralph
38 years of experience
Nissan Versa L4-1.6L - Car is not shifting into park - Federal Way, Washington
Ralph was great and very caring.

Excellent Rating

(662)

Rating Summary
629
17
4
5
7
629
17
4
5
7
Number of Nissan Versa services completed
7282+
services done by our mechanics
TOTAL NUMBER OF EXPERT Nissan MECHANICS
1500+
experts on our platform

Recent articles & questions

10 Best Car Wax Products
Protect your car paint with car wax and car polish. Car waxes should be regularly applied and range from $4-40 - much less than a car paint job.
P0973 OBD-II Trouble Code: Shift Solenoid A Control Circuit Low
P0973 means there is an error with the shift solenoid A control circuit due to a faulty solenoid, control circuit,or low or dirty transmission fluid.
P0549 OBD-II Trouble Code: Exhaust Gas Temperature Sensor Circuit High Bank 2 Sensor 1
P0549 means the ECM found a fault with the exhaust gas temperature sensor circuit, caused by its damage or related electrical issues.

Clutch line not bleeding

The clutch and brakes don't use the same master cylinder. They both use brake fluid, but that is the only things they have in common as far as parts go. The clutch will have its own master cylinder, line and...

Just bought a new car and the transmission is slow going into drive and reverse. Plus skipped when I attempted to hit the gas hard

What you are describing is often a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's...

replaced oil pressure sensor with no gasket i revved the engine to 2500 rpm's and no leak is it good?

Hi Kyle. I can't guarantee that you're good here. The oil pressure sensor gasket helps to maintain the seal when the engine reaches operating temperature and gets hot. When this happens, the metal between the sensor and the block tends...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com