Mitsubishi Raider Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(14)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(14)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mitsubishi Raider Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2007 Mitsubishi RaiderV6-3.7LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2009 Mitsubishi RaiderV6-3.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2006 Mitsubishi RaiderV8-4.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2007 Mitsubishi RaiderV8-4.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2006 Mitsubishi RaiderV6-3.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2008 Mitsubishi RaiderV6-3.7LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
Show example Mitsubishi Raider Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mitsubishi mechanics

Real customer reviews from Mitsubishi owners like you.

Excellent Rating

(14)

Rating Summary
14
0
0
0
0
14
0
0
0
0

Carlos

28 years of experience
517 reviews
Carlos
28 years of experience
Mitsubishi Raider V6-3.7L - Water Pump Replacement - Moreno Valley, California
Outstanding service

Toby

10 years of experience
100 reviews
Toby
10 years of experience
Mitsubishi Raider V8-4.7L - Oxygen Sensor Replacement (Front/Upper/Upstream, Rear/Lower/Downstream) - Fort Worth, Texas
Toby was on-time a little early even. Was very personable, got right to work inspecting my truck and installing new O2 sensors. I had replaced spark plugs previously and had not reinstalled the baffle for the mass air sensor and Toby took the time to install while finishing up his work.

TJ

26 years of experience
362 reviews
TJ
26 years of experience
Mitsubishi Raider V6-3.7L - Drive Belt Tensioner - Fort Myers, Florida
TJ was very knowledgeable and kind. We definitely will be asking for him again.

David

13 years of experience
415 reviews
David
13 years of experience
Mitsubishi Raider V6-3.7L - Window is not working - Acworth, Georgia
He was prompt and did a great job at diagnosing the issue. Great to work with!

Excellent Rating

(14)

Rating Summary
14
0
0
0
0
14
0
0
0
0
Number of Mitsubishi Raider services completed
154+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mitsubishi MECHANICS
700+
experts on our platform

Recent articles & questions

How a Manual Transmission Works
A A manual transmission helps a vehicle achieve a desired speed through the use of gears, a clutch, and a shifter. It works like this: when the driver wants to shift gears, he or she pushes in the clutch pedal...
Symptoms of a Bad or Failing Speedometer Cable and Housing
Common signs include the speedometer fluctuating erratically, not registering, or making squealing noises.
P0605 OBD-II Trouble Code: Internal Control Module ROM Error
P0605 P0605 code definition Internal Control Module ROM Error (Module Identification Defined by SAE J1979) What the P0605 code means The Engine Control Module (ECM) is responsible for many major vehicle functions such as ignition timing, anti lock-braking, fuel injection,...

Clock not working

The clock fuse would need to be checked first. If that is okay, then the clock should be checked to make sure that it has a proper supply of power and grounds. If that is okay, then a replacement clock...

Car feels like it is in neutral

This is often a sign of low transmission fluid (https://www.yourmechanic.com/services/transmission-fluid-service) or a faulty transmission control solenoid. As you know, automatic transmissions use pressurized hydraulic fluid to change gears. Every time a gear change is required, the car's computer activates a...

I have 2012 Acura TL that has 69k miles. Today for the first time when I was driving in rain the car jerked at 20mph and at 21mph

Hi Tina. Thanks for contacting us today. It really depends on what your car is actually doing that would lead to a possible reason. If it is pulling to one side of the road, it could have been caused by...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com