Mitsubishi Outlander Sport Power Steering Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(92)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(92)

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Mitsubishi Outlander Sport Power Steering Pump Replacement is $564 with $382 for parts and $182 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2012 Mitsubishi Outlander SportL4-2.0LService typePower Steering Pump ReplacementEstimate$964.64Shop/Dealer Price$1160.11 - $1735.97
2011 Mitsubishi Outlander SportL4-2.0LService typePower Steering Pump ReplacementEstimate$952.93Shop/Dealer Price$1146.10 - $1720.24
2017 Mitsubishi Outlander SportL4-2.0LService typePower Steering Pump ReplacementEstimate$952.93Shop/Dealer Price$1146.13 - $1720.30
2014 Mitsubishi Outlander SportL4-2.0LService typePower Steering Pump ReplacementEstimate$952.93Shop/Dealer Price$1146.13 - $1720.29
2015 Mitsubishi Outlander SportL4-2.0LService typePower Steering Pump ReplacementEstimate$952.93Shop/Dealer Price$1148.04 - $1723.65
2013 Mitsubishi Outlander SportL4-2.0LService typePower Steering Pump ReplacementEstimate$952.93Shop/Dealer Price$1146.31 - $1720.61
2016 Mitsubishi Outlander SportL4-2.0LService typePower Steering Pump ReplacementEstimate$952.93Shop/Dealer Price$1146.15 - $1720.33
Show example Mitsubishi Outlander Sport Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

  • Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
  • Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
  • Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
  • Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

  • If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
  • If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
  • The threaded connectors to the pump inlet and outlet are loosened and removed.
  • Any mounting bolts and brackets are removed so the pump can be removed.
  • If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
  • The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
  • Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

  • Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
  • Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mitsubishi mechanics

Real customer reviews from Mitsubishi owners like you.

Excellent Rating

(92)

Rating Summary
89
0
0
0
3
89
0
0
0
3

Nikolay

21 years of experience
62 reviews
Nikolay
21 years of experience
Mitsubishi Outlander Sport L4-2.0L - Car is not starting - San Marcos, California
This is the second time that Nikolays was out for servicing two different cars. Each experience with him has been excellent. He communicated his progress and updated me as needed. I would highly recommend him!

James

31 years of experience
1039 reviews
James
31 years of experience
Mitsubishi Outlander Sport L4-2.0L - Alternator - Orlando, Florida
very good.

Pete

17 years of experience
192 reviews
Pete
17 years of experience
Mitsubishi Outlander Sport L4-2.0L - Oil Change - Chula Vista, California
Arrived sharp. He worked happily and was very nice even in the pouring rain.

Travis

11 years of experience
296 reviews
Travis
11 years of experience
Mitsubishi Outlander Sport L4-2.0L - Battery - Houston, Texas
Great service, answered all my questions and explained the work. Thank you Travis.

Excellent Rating

(92)

Rating Summary
89
0
0
0
3
89
0
0
0
3
Number of Mitsubishi Outlander Sport services completed
1012+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mitsubishi MECHANICS
800+
experts on our platform

Recent articles & questions

P2294 OBD-II Trouble Code: Fuel Pressure Regulator 2 Control Circuit/Open
P2294 code definition Fuel Pressure Regulator 2 Control Circuit/Open What the P2294 code means When trouble code P2294 sets, it means that...
P0849 OBD-II Trouble Code: Transmission Fluid Pressure Sensor/Switch B Circuit Intermittent
P0849 means there is an issue with the transmission fluid levels, possibly due to hydraulic line blockage, faulty components, or bad fluid level.
How Long Does a Clutch Cable Last?
The The clutch cable is an essential part of your vehicle’s clutch system. The clutch is a device that engages and disengages the power transmission, and allows you to shift gears while you are driving. Manual transmission vehicles have a...

Rain water getting into the car

The water leaking into your front floor is most likely coming from the sun roof. The sun roof has two water drains. Each drain runs next to the windshield, inside of the left and right side pillars, called the A...

EPS light

Hello. The EPS light comes on when the computer detects an issue with the vehicle's electronic power steering system. If the computer detects an issue with the system it will set off the warning light to notify the driver of...

The locksmith cut To jaguar X type keys for my car and it would not make my car Creek

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com