Mercury Colony Park Car Battery Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(54)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(54)

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Mercury Colony Park Car Battery Replacement is $300 with $160 for parts and $140 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1991 Mercury Colony ParkV8-5.0LService typeCar Battery ReplacementEstimate$475.20Shop/Dealer Price$558.85 - $801.70
1990 Mercury Colony ParkV8-5.0LService typeCar Battery ReplacementEstimate$440.63Shop/Dealer Price$516.12 - $738.48
Show example Mercury Colony Park Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

  • Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
  • Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
  • Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

  • A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
  • The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
  • Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
  • The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
  • Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
  • The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

  • The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
  • Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
  • Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
  • Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercury mechanics

Real customer reviews from Mercury owners like you.

Excellent Rating

(54)

Rating Summary
53
1
0
0
0
53
1
0
0
0

Fred

18 years of experience
389 reviews
Fred
18 years of experience
Mercury Grand Marquis V8-4.6L - Battery - Conroe, Texas
He did great in getting our car to start. Prices were upfront which helps.

AJ

10 years of experience
21 reviews
AJ
10 years of experience
Mercury Sable V6-3.8L - Car Battery Replacement - Bellevue, Washington
very professional, polite.

Michael

49 years of experience
124 reviews
Michael
49 years of experience
Mercury Villager V6-3.0L - Battery - Memphis, Tennessee
As usual Michael was right on time, friendly as always. Michael explained all the work that was going to be done and get it done in a very timely matter. I always look forward to working with you guys especially Michael.

Clarissa

28 years of experience
251 reviews
Clarissa
28 years of experience
Mercury Sable V6-3.0L - Battery - West Chester, Pennsylvania
Great. She was informative and very easy to understand. I'm requesting her .

Excellent Rating

(54)

Rating Summary
53
1
0
0
0
53
1
0
0
0
Number of Mercury Car Battery Replacement services completed
594+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercury MECHANICS
600+
experts on our platform

Recent articles & questions

P2098 OBD-II Trouble Code: Post Catalyst Fuel Trim System Too Lean Bank 2
What the P2098 code means? P2098 is an OBD-II generic code for the engine control module (ECM) detecting the post catalyst O2...
Symptoms of a Bad or Failing Console Light Bulb
If your car's center console light is dim, flickering, or not working at all, you may need to replace the console light bulb.
3 Essential Things to Know About Your Car’s Shock Absorbers
A A shock absorber is a device inside your vehicle that is connected to the suspension. It is designed to absorb and dampen shocks while you are driving down the road. Shock absorbers work by converting the kinetic energy of...

Why does the hood of my 2012 BMW 328i get really hot?

The engine compartment will get very hot when the engine is running and with the vehicle you have most of the heat is radiated out through the hood. If you feel your hood is getting hotter than it should be...

I have a 1978 Corvette thats been sitting for 10 years... What should I start with to get it running again?

I would suggest doing the following (Not necessarily in this order), prior to starting the car: 1.) Replace Battery 2.) Remove all old gas from tank and carb 3.) Rebuild the carb 4.) Replace spark plugs and wires (Spray WD-40...

Toyota Celica GT 1983 - Knocking noise when car is moving forward, gets louder and faster as the car gets faster.

The first thing to do is get out your lug wrench and be sure all of the wheel bolts are tight (https://www.yourmechanic.com/article/how-to-tighten-lug-nuts-by-john-hege) if you don't find anything that way, your problem could be in the brakes somewhere or even a...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com