Mercedes-Benz ML500 Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Mercedes-Benz ML500 Car Battery Replacement is $403 with $263 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2003 Mercedes-Benz ML500V8-5.0L	Service typeCar Battery Replacement	Estimate$680.38	Shop/Dealer Price$818.03 - $1216.79
2006 Mercedes-Benz ML500V8-5.0L	Service typeCar Battery Replacement	Estimate$671.37	Shop/Dealer Price$805.92 - $1202.37
2002 Mercedes-Benz ML500V8-5.0L	Service typeCar Battery Replacement	Estimate$671.37	Shop/Dealer Price$805.97 - $1202.44
2007 Mercedes-Benz ML500V8-5.0L	Service typeCar Battery Replacement	Estimate$671.37	Shop/Dealer Price$805.97 - $1202.44
2005 Mercedes-Benz ML500V8-5.0L	Service typeCar Battery Replacement	Estimate$671.37	Shop/Dealer Price$808.54 - $1206.95
2004 Mercedes-Benz ML500V8-5.0L	Service typeCar Battery Replacement	Estimate$671.37	Shop/Dealer Price$806.21 - $1202.87

Show example Mercedes-Benz ML500 Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(4)

Rating Summary

4

0

0

0

0

4

0

0

0

0

SEE REVIEWS NEAR ME

Bereketeab

5 years of experience

101 reviews

Request Bereketeab

Bereketeab

5 years of experience

Request Bereketeab

by Levi Cook

ML500 2006 - Battery - Elk Grove, CA

Bereketeabs was on time, very professional and took care of my service call as expected. It was a pleasure having him do the work.

Joel

9 years of experience

58 reviews

Joel

9 years of experience

by Louis Kraml

ML500 2006 - Rear Window Wiper Blade - Lewisville, TX

Excellent Mechanic and nice person.

Peter

22 years of experience

479 reviews

Peter

22 years of experience

by Gabriel Alonso

ML500 2003 - AC is not working - Reseda, CA

Peter took his Time to check out and diagnose my vehicles problem. I was able to add some Freon and the cooling system is most definitely getting colder. I’m gonna drive it for the next few days as recommended and see where I’m at and go from there. Thank you for your time Peter

Raymond

25 years of experience

137 reviews

Request Raymond

Raymond

25 years of experience

Request Raymond

by Kathryn Chlon

ML500 2003 - Air Pump - Apple Valley, CA

Raymond is a great mechanic. I’m divorced and I have several cars so having a mechanic that I can trust makes all the difference in the world. I definitely have recommend him and I will keep recommending him

Excellent Rating

(4)

Rating Summary

4

0

0

0

0

4

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

A Buyer’s Guide to the 2012 Nissan Juke

The The 2012 Nissan Juke is part crossover, part sports car, and part radical looking car. It has five doors, folding rear seats, and a rear hatch for easy access to the cargo area. The seats fold flat offering extra...

Hummer Certified Pre-Owned (CPO) Car Program

If If you are in the market for a used Hummer vehicle, you may want to check out cars under their certified pre-owned program. Many manufacturers have a certified pre-owned (CPO) program, and each one is set up differently. Read...

The Guide to Colored Curb Zones in Louisiana

Drivers Drivers in Louisiana need to be aware of all of the rules of the road, including the rules for where they can and cannot park their vehicle. If they are not careful about where they park, they can expect...

what could be causing the drain on the battery

Depending on the van and its accessories the first thing to do is to look and see if the interior lights or hood light are staying on. Take the bulb out of the hood light and see if the draw...

Where is the yaw rate sensor located?

Hello, thanks for writing in about your Toyota Sequoia. The yaw sensor is located below the center console. It's mounted to the floor at the rear of the console. The console needs to be removed in order to replace it....

Abs light is on what is the problem?

Your car is equipped with wheel speed sensors at each of the four wheels which monitor wheel speed while relaying this information constantly to the ABS and traction control system which are controlled by the car's ECU. When the ECU...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com