Mercedes-Benz GLC63 AMG S Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(5,670)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(5,670)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz GLC63 AMG S Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2021 Mercedes-Benz GLC63 AMG SV8-4.0L TurboService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2018 Mercedes-Benz GLC63 AMG SV8-4.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2019 Mercedes-Benz GLC63 AMG SV8-4.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2020 Mercedes-Benz GLC63 AMG SV8-4.0L TurboService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
Show example Mercedes-Benz GLC63 AMG S Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(5,670)

Rating Summary
5,278
191
54
28
119
5,278
191
54
28
119

William

33 years of experience
69 reviews
William
33 years of experience
Mercedes-Benz E350 V6-3.5L - Reduced Power light is on - Sun City, California
Excellent customer service. Patient as well. Highly recommended.

Jeremy

20 years of experience
630 reviews
Jeremy
20 years of experience
Mercedes-Benz C300 V6-3.0L - Starter - West Palm Beach, Florida
Very intelligent and courteous mechanic with foreign cars. Communication on status and schedule was a major plus.

Chris

16 years of experience
419 reviews
Chris
16 years of experience
Mercedes-Benz * * - Oil Change - Daly City, California

Clifton

30 years of experience
289 reviews
Clifton
30 years of experience
Mercedes-Benz GL450 V8-4.6L - Battery - West Palm Beach, Florida
He went above and beyond to get my car back on the road.. He was awesome.

Excellent Rating

(5,670)

Rating Summary
5,278
191
54
28
119
5,278
191
54
28
119
Number of Mercedes-Benz services completed
62370+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

What Is Engine Braking?
Drivers can use engine braking to slow the speed of their engine and vehicle. Engine decompression helps your brakes last longer and car stop sooner.
The Traveler’s Guide to Driving in Australia
Australia Australia is a popular vacation destination, but people don’t always realize just how large the country is and how much space there is between destinations they might want to visit. Having a rental car that you can use for...
California Speed Limits, Laws, and Fines
Following Following is an overview of the laws, limits, and fines as they relate to speeding traffic violations in the state of California. Speed limits in California California has a very different way of setting its speed limits than most...

Fuel consumption issues after crankshaft position sensor reset

Hello. If your lights are coming on and off then there may still be an issue somewhere with the vehicle. If there was a recent reset due to an issue with the crank position sensor it may be possible that...

Jeep Compass slow turn bogging down issue, TC/ABS/ESP/4WD.

Hi There, What you are describing sounds like it may be related to a faulty transmission control module or potentially a bad transmission speed sensor. The speed sensor reads the rotational speed of the reluctor wheel, located within the transmission....

Ground strap firewall to ? Can I cut and put new strap where I can reach

There are a number of ways to resolve this issue. The first of which is to trace the wire until you find the other end and replace the wire with the OEM part. You could also try to simply attatch...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com