Mercedes-Benz C320 Reduced Power light is on Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(60)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(60)

Reduced Power light is on Inspection Service

How much does a Reduced Power light is on Inspection cost?

On average, the cost for a Mercedes-Benz C320 Reduced Power light is on Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2005 Mercedes-Benz C320V6-3.2LService typeReduced Power light is on InspectionEstimate$114.99Shop/Dealer Price$132.49 - $145.62
2002 Mercedes-Benz C320V6-3.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2004 Mercedes-Benz C320V6-3.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.52 - $125.67
2001 Mercedes-Benz C320V6-3.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.48 - $125.60
2003 Mercedes-Benz C320V6-3.2LService typeReduced Power light is on InspectionEstimate$94.99Shop/Dealer Price$112.55 - $125.72
Show example Mercedes-Benz C320 Reduced Power light is on Inspection prices

A Reduced Power light usually indicates a fairly serious problem with the throttle system. When this light illuminates the vehicle will often go into a “safe mode”, which will severely limit the speed of the car and in some cases will render the vehicle un-drivable.

Since the Reduced Power light can trigger for a number of different reasons, tracking down the exact cause is extremely important, if the vehicle is not properly diagnosed and repaired, the Reduced Power light will trigger again, putting the vehicle in safe mode.

How this system works:

When the vehicle’s computer detects a fault in the engine that affects its drivability, performance, transmission or emission system it will trigger the reduced power light. It will also trigger if there is an issue with the electronic throttle, the accelerator pedal or the throttle module.

When a vehicle goes into reduced power mode it will seriously impact its performance. Some vehicle will be restricted to idle speed while others restrict speed to 20-30 miles per hour. The Reduced Power trigger will save Diagnostic Trouble Codes (DTCs), which will indicate where the fault occurred. In most cases, a Restricted Power light is related to a throttle body or the connector.

Common reasons for this to happen:

  • Faulty Throttle Body: A throttle body is part of the of the air intake system which helps control the amount of air going into the engine. If a throttle body is failing the engine will not get the correct mixture of air and fuel. This can trigger the Reduced Power light as well as lead to a poor running engine. It can also trigger the Check Engine light.

  • Failing Throttle Position Sensor: The throttle position sensor tells the vehicle computer the position of the gas pedal. The computer uses this information to calculate the proper amount of air and fuel to send to the engine. The throttle position sensor also controls shifting the gears of a vehicle, which means that a faulty throttle position sensor will prevent a car from changing gears. If this part is failing, the Reduced Power light will trigger.

  • Faulty Engine Control Unit: The engine control unit is an essential component of a vehicles computer. It regulates and controls many systems, including the drive train and parts of the engine. If a fault is detected in this crucial part, it can trigger the Reduced Power light as well as the Check Engine light. This is a major issue that should be investigated as soon as possible.

  • Faulty Wiring: Exposed or damaged wires can cause issues with the any of these components and will possibly trigger the Reduced Power light. A loose wiring crimp can also be the culprit. Wiring issues can be tricky to track down so using a professional mechanic is a necessity.

  • Malfunctioning Oxygen Sensors: Oxygen sensors are responsible for measuring how rich or lean exhaust gases are leaving a vehicles combustion chamber. The vehicle’s computer uses this information to constantly adjust the amount of fuel going into the engine. A failing or dirty sensor can put too much or too little fuel into the engine. While a failing oxygen sensor will usually trigger a Check Engine light it is possible that the Reduced Power light could also trigger.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the Reduced Power light issue, ​and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How it's done:

The mechanic will inspect your vehicle's air intake system, electrical wiring and sensors, including the throttle body and oxygen sensors, along with other important components. It may be necessary for the mechanic to test drive the car to verify the complaint and provide an accurate diagnosis.

How important is this service?

The Reduced Power light only illuminates if there is a serious issue with the vehicle that must be addressed immediately. In almost all cases, the throttle or the vehicles computer will be malfunctioning which can make driving the vehicle dangerous. While it varies by manufacturer, most vehicles that go into “safe mode” will stay there until the error codes are read by a code scanner.

If the vehicle Reduced Power light illuminates the vehicle should immediately be inspected, diagnosed and repaired.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mercedes-Benz mechanics

Real customer reviews from Mercedes-Benz owners like you.

Excellent Rating

(60)

Rating Summary
56
0
2
0
2
56
0
2
0
2

Attila

19 years of experience
906 reviews
Attila
19 years of experience
Mercedes-Benz C320 V6-3.2L - Car is not starting - Plainfield, New Jersey
Very nice person

Justin

4 years of experience
31 reviews
Justin
4 years of experience
Mercedes-Benz C320 V6-3.2L - Axle / CV Shaft Assembly Replacement (Driver Side Front, Passenger Side Front) - Philadelphia, Pennsylvania
Great job, very pleased

Dameron

17 years of experience
171 reviews
Dameron
17 years of experience
Mercedes-Benz C320 V6-3.2L - Brake Pads Replacement (Rear) - Indianapolis, Indiana
Expert knowledge. Professional work. Timely service.

Joseph

27 years of experience
578 reviews
Joseph
27 years of experience
Mercedes-Benz C320 V6-3.2L - Coolant is leaking - Sugar Land, Texas
Joseph was honest and knowledgeable

Excellent Rating

(60)

Rating Summary
56
0
2
0
2
56
0
2
0
2
Number of Mercedes-Benz C320 services completed
660+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mercedes-Benz MECHANICS
1100+
experts on our platform

Recent articles & questions

Is it Safe to Drive With a Gas Leak?
If you notice the smell of gas once you get into your vehicle, this could be a sign of a gas leak. A...
How to Keep Your Convertible’s Soft Top Looking Great
As As you take a look outside your living room window you notice something odd - the crocuses are beginning to bloom. Ah, that means spring is around the corner, and spring means road trips. This year, in addition to...
C1101 OBD-II Trouble Code: ABS Hydraulic Valve Circuit Failure
Trouble code C1101 means the engine control unit (ECU) has detected an unspecified failure in the ABS hydraulic valve circuit.

Recommendation on buying a reliable and fuel-efficient cargo van for driving moderate weight

If you want a cargo van, I would go for a Ford cargo van. If you get one of their eco-boost engines, you can get decent horsepower in them, which will give them decent gas mileage. Realize that they all...

Acceleration high-pitched whistling

This generation of Toyota Previas has a known issue with this that is typically related to something called a "flex pipe" which is a part of the exhaust system that sits in front of the catalytic converter. The fact that...

what will happen if i drive on crunchy front berrings

Hello...it is wonderful to hear from a Tercel owner!! I owned a 1985 Tercel for 25 years!!! One day, on the freeway, the rust on the front sub-frame finally caused the car to basically "crack" where the control arm is...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com