Mazda MX-5 Miata Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(129)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(129)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Mazda MX-5 Miata Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2013 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2016 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2014 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2012 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2010 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2015 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2019 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2006 Mazda MX-5 MiataL4-2.0LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Mazda MX-5 Miata Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mazda mechanics

Real customer reviews from Mazda owners like you.

Excellent Rating

(129)

Rating Summary
125
2
0
1
1
125
2
0
1
1

Chris

16 years of experience
4 reviews
Chris
16 years of experience
Mazda MX-5 Miata L4-2.0L - Car is not starting - Chattanooga, Tennessee
Nice man, very clear on the problem and explained exactly what it would take to fix it.

Fabrice

20 years of experience
134 reviews
Fabrice
20 years of experience
Mazda MX-5 Miata L4-2.0L - Car will not turn over - Orlando, Florida
Fabrice was professional, business like, knowledgeable and a gentleman. He contacted me in advance to inform me that he was running late. Issue was determined...a dead bsttery. Many thanks.

Ben

41 years of experience
1416 reviews
Ben
41 years of experience
Mazda MX-5 Miata L4-2.0L - Brake Pads Replacement (Front) - Houston, Texas
His schedule changed so I was able to move my appointment time earlier in the day, so that was a very positive start to an overall great experience. As this was my first time using this type of service, I was a bit apprehensive and didn’t know what to expect. Ben put me at ease when he arrived. To my surprise, the front brakes replacement and brake fluid flush took no longer than 20 minutes for him to complete. If I need repairs in the future, I will definitely ask for Ben and so should you!

Peter

25 years of experience
519 reviews
Peter
25 years of experience
Mazda MX-5 Miata L4-2.0L - Clutch pedal goes all the way to the floor - Sylmar, California
Explained everything and was very thorough.

Excellent Rating

(129)

Rating Summary
125
2
0
1
1
125
2
0
1
1
Number of Mazda MX-5 Miata services completed
1419+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mazda MECHANICS
1100+
experts on our platform

Recent articles & questions

How to Apply a Clear Base Coat to a Car
Much Much of a vehicle's appeal has nothing to do with its performance and is purely superficial. Although a car's speed and agility on the road is important, it means very little in terms of the total package if it...
How to Renew Your Car Registration in Michigan
Getting Getting your car registered with the Michigan Secretary of State is important when trying to keep a car legal. The fees that you will pay to get the registration will go to increase the safety and functionality of the...
I Have No Idea What's Wrong With My Car - Where Do I Begin?
If If you’re like the majority of people in the U.S., you use a car to get from Point A to Point B and rely on all the parts working properly. None of us expects to break down on the...

Which Spark Plugs Are Best for Normal Driving?

This may sound rather silly, but for normal driving, the best spark plug to use is the ones that are designed by the vehicle manufacturer for use in your particular vehicle. The reason that I say this is because not...

Put a water pump and timing belt on it and alternator it crunk up for 20 seconds and cut off now it wont start but does tirn over

Assuming the vehicle was running before the timing belt was replaced, I have to ask, are you sure you lined up the timing marks correctly? This would be the first thing I would check myself if I were working on...

1996 Olds Aurora OBDII P0603 PCM keep alive memory, car is in limp mode and running like it's off timing

Correct the ground connection first, in case that problem is a cause of the trouble code. P0603 does represent an electrical system fault. In practice, this particular fault might be found as battery terminal corrosion or loose connections, Keep Alive...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com