Mazda MX-30 EV Clean and Repack Wheel Bearing at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(4,896)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(4,896)

Clean and Repack Wheel Bearing Service

How much does a Clean and Repack Wheel Bearing cost?

On average, the cost for a Mazda MX-30 EV Clean and Repack Wheel Bearing is $226 with $0 for parts and $226 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2022 Mazda MX-30 EVElectricService typeClean and Repack Wheel BearingEstimate$233.58Shop/Dealer Price$241.65 - $247.70
Show example Mazda MX-30 EV Clean and Repack Wheel Bearing prices

What is cleaning and repacking the wheel bearings all about?

A car’s wheels rotate on tapered-roller bearings which fit between the stationary axle spindle and the rotating wheel’s hub/brake mechanism. There are bearings on the inner and outer side of the hub to properly support the wheel. These are greased when installed, but the grease can, and does, break down over time, allowing dry contact between the various elements. When left unattended, this will lead to wear and, ultimately, to bearing failure.

Keep in mind:

  • Since noise is the first symptom of metal-to-metal contact, it’s likely that damage has already occurred, and that bearing replacement may be necessary.
  • The job will require the removal of the wheel and brake assembly, so it might be advisable to inspect the brake pads, steering tie rods and suspension pieces in the process.
  • If you’re going to do one wheel, it’s only logical that you should also do the other side.

How it's done:

  • The vehicle is raised and supported on jack stands
  • The front or rear wheels, brakes and hubs are removed from the vehicle
  • The front or rear wheel hubs, bearings are cleaned and greased then install a new grease seal in hub
  • The front or rear wheels, brakes and hubs are installed back on the vehicle
  • The vehicle is lowered off of the jack stands

Our recommendation:

Consider having this job done when your vehicle reaches high mileage, particularly if it has been operated with heavy loads or on unusually bumpy roads.

What is a common symptom indicating you need to clean and repack the wheel bearings?

  • Any noise noticeable from the wheels. It can start as a squeal, and then develop into a growl or even a grinding sound.

How important is this service?

A catastrophic wheel bearing failure can lead to the wheel coming off the car. Obviously, that could cause an accident or, at the very least, serious damage to the vehicle. It’s certainly worth discussing with one of our mechanics.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Mazda mechanics

Real customer reviews from Mazda owners like you.

Excellent Rating

(4,896)

Rating Summary
4,605
154
37
19
81
4,605
154
37
19
81

David

35 years of experience
67 reviews
David
35 years of experience
Mazda B2300 L4-2.3L - Clean and Repack Wheel Bearing - Lafayette, California
David was professional. personable, and honest. Very clear about what the job entailed, i.e. time, cost, etc.

Chris

21 years of experience
448 reviews
Chris
21 years of experience
Mazda 3 L4-2.5L - Power Steering Fluid Service - Portland, Oregon
Great - prompt, courteous and professional.

Rick

48 years of experience
43 reviews
Rick
48 years of experience
Mazda RX-8 R2-1.3L - Headlight Bulb Replacement (Driver Side Low Beam, Passenger Side Low Beam) - Boulder, Colorado

Emmette

37 years of experience
282 reviews
Emmette
37 years of experience
Mazda CX-9 V6-3.7L - ABS Light is on - Arlington, Virginia
Emmette was professional, straightforward and prompt. A Mazda dealership, claimed we needed to replace both ABS sensors for almost $600. Emmette did a full inspection. The cables were just loose. Mazda wanted to charge $2k for a few other fixes, which I found to be suspicious due to the age of the car. The detailed report assured us, the dealership was trying to mislead us. We will be booking Emmette again. Primarily, because he gained our trust!

Excellent Rating

(4,896)

Rating Summary
4,605
154
37
19
81
4,605
154
37
19
81
Number of Mazda services completed
53856+
services done by our mechanics
TOTAL NUMBER OF EXPERT Mazda MECHANICS
1100+
experts on our platform

Recent articles & questions

Top 10 Scenic Drives in West Virginia
West Virginia is a particularly beautiful region of the United States being situated within the Appalachians and home to rolling hills and sweeping valleys full of fertile soil. There are also numerous lakes and rivers, full of opportunities to boat...
How to Customize a Chrysler 300
The The Chrysler 300 (https://www.yourmechanic.com/article/a-buyer-s-guide-to-the-2012-chrysler-300) is an extremely popular model of sedan with sleek styling reminiscent of more expensive brands like the Bentley at a far more affordable price. It’s a great long-distance cruiser with get-up-and-go, which inspires great loyalty...
How to Become a Certified Mobile Vehicle Inspector (State Car Inspector Certified) in Virginia
Automotive technician jobs include mobile vehicle inspectors. Learn how to do car checks in Virginia through the Universal Technical Institute.

What does the speedometer display?

There are quite a few important gauges located on the dash of your car. The speedometer is one of the most important when driving. It measures how fast your car is traveling and displays that information via a needle and...

how to tell if my mass air sensor or my tps is the problem?

You did not state the model and size of engine you have? Most Nissan distributor engines have a base timing between 13 and 17 degrees BTDC (before top dead center) at 700 to 800 RPM. If you have the timing...

Overheating

Hello, thank you for writing in. You have done everything reasonably possible to resolve the problem. With that being said, if the new radiator did not come with a new radiator cap, you will want to start there. If that...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com