Kia Forte Koup Power Steering Pump Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Kia Forte Koup Power Steering Pump Replacement is $579 with $397 for parts and $182 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2012 Kia Forte KoupL4-2.4L	Service typePower Steering Pump Replacement	Estimate$1120.88	Shop/Dealer Price$1355.41 - $2048.45
2010 Kia Forte KoupL4-2.4L	Service typePower Steering Pump Replacement	Estimate$1109.17	Shop/Dealer Price$1341.40 - $2032.72
2011 Kia Forte KoupL4-2.4L	Service typePower Steering Pump Replacement	Estimate$1109.17	Shop/Dealer Price$1341.43 - $2032.78
2016 Kia Forte KoupL4-2.0L	Service typePower Steering Pump Replacement	Estimate$983.93	Shop/Dealer Price$1184.88 - $1782.29
2013 Kia Forte KoupL4-2.4L	Service typePower Steering Pump Replacement	Estimate$1109.17	Shop/Dealer Price$1343.34 - $2036.13
2013 Kia Forte KoupL4-2.0L	Service typePower Steering Pump Replacement	Estimate$1109.17	Shop/Dealer Price$1341.61 - $2033.09
2011 Kia Forte KoupL4-2.0L	Service typePower Steering Pump Replacement	Estimate$1109.17	Shop/Dealer Price$1341.45 - $2032.81
2014 Kia Forte KoupL4-2.0L	Service typePower Steering Pump Replacement	Estimate$983.93	Shop/Dealer Price$1184.88 - $1782.29

Show example Kia Forte Koup Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
The threaded connectors to the pump inlet and outlet are loosened and removed.
Any mounting bolts and brackets are removed so the pump can be removed.
If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Kia mechanics

Real customer reviews from Kia owners like you.

Excellent Rating

(33)

Rating Summary

33

0

0

0

0

33

0

0

0

0

SEE REVIEWS NEAR ME

Francisco

10 years of experience

45 reviews

Request Francisco

Francisco

10 years of experience

Request Francisco

by Yliana Lara

Forte Koup 2014 - Battery - Austin, TX

Very quick and helpful!

Michael

20 years of experience

391 reviews

Request Michael

Michael

20 years of experience

Request Michael

by Kaui Pasa

Forte Koup 2011 - Heater Blower Motor - Gilbert, AZ

This was my first experience with Your Mechanic booking and it was amazing! The shop I took it to initially wanted to charge $820 for the repair, I paid $276 through this platform total, I will only use this service for all my car services from here on out. Michael was informative, helpful, and replaced my blower motor and resistor quickly. I highly recommend Michael’s services!

Excellent Rating

(33)

Rating Summary

33

0

0

0

0

33

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

A Buyer’s Guide to the 2012 Infiniti QX56

If If you want an SUV that offers comfortable seating for the entire family, a luxuriously smooth, enjoyable ride and the ability to tow all those toys when you go on vacation, the 2012 Infiniti QX56 might be your answer....

How to Prepare for the Utah Driver’s Written Test

It It is not possible to get a learner’s permit in Utah until you have first taken and passed your driver’s written test. Driving is an important responsibility, and you need to prove to the state that you have the...

P0596 OBD-II Trouble Code: Cruise Control Servo Control Circuit High

P0596 means there is an issue with the cruise control servo control circuit. This can be caused by a faulty unit, blown fuses, or broken wires.

Convertible stuck open

Hello. This commonly happens on this vehicle for a number of reasons. Most of the time, it is because of a battery voltage loss. It can also happen if one of the sensors are not reading correctly. When either of...

Rod Knock

Hello. This engine does have a series of common issues that can cause a knock. I have seen quite a few of them with rod knocks, but most of the time the issue is the timing chain. The warranty company...

My car will accelerate but won't drive or go in reverse. I also have an antifreeze leak as well. Does this automatically mean I ne

You should have it checked at least since it can be a bad shift cable or a bad transmission or low on fluid can all cause it not to go into gear.

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com