Jeep Wagoneer Car Battery Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Car Battery Replacement Service

How much does a Car Battery Replacement cost?

On average, the cost for a Jeep Wagoneer Car Battery Replacement is $300 with $160 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2023 Jeep WagoneerV8-5.7L Hybrid	Service typeCar Battery Replacement	Estimate$755.00	Shop/Dealer Price$908.60 - $1361.30
2022 Jeep WagoneerV8-5.7L Hybrid	Service typeCar Battery Replacement	Estimate$745.99	Shop/Dealer Price$897.82 - $1349.20
2024 Jeep WagoneerV8-5.7L Hybrid	Service typeCar Battery Replacement	Estimate$745.99	Shop/Dealer Price$897.85 - $1349.24
2024 Jeep WagoneerL6-3.0L Turbo	Service typeCar Battery Replacement	Estimate$745.99	Shop/Dealer Price$897.85 - $1349.24
2023 Jeep WagoneerL6-3.0L Turbo	Service typeCar Battery Replacement	Estimate$745.99	Shop/Dealer Price$899.32 - $1351.82
1990 Jeep WagoneerL6-4.0L	Service typeCar Battery Replacement	Estimate$455.37	Shop/Dealer Price$534.71 - $768.25

Show example Jeep Wagoneer Car Battery Replacement prices

What are car batteries and how do they work?

A car battery is an energy storage device that relies on a chemical reaction within the battery to produce electricity. The stored electrical energy is used to initially operate the starter motor, ignition system, and fuel system on your vehicle. Once your car engine is running, the alternator supplies the electricity needed for all vehicle systems and charges the battery to replace the electric energy used when starting a car.

Most electric vehicles have a traction battery which is in addition to the standard 12 volt battery that is used to start the car engine. Traction batteries also convert chemical energy to supply electrical energy but operate at higher voltages and often are monitored by the PCM (Powertrain Control Module).

Battery

When to replace a car battery?

Your car doesn’t start. A new battery has a specified capacity to provide power. This capacity is referred to as the cranking amps rating of the battery. As a battery ages, the actual amps that a battery can supply becomes lower than its original rating Once the cranking amps fall below a critical threshold, it will be difficult or impossible to start your car.
Battery or charging system warning light is illuminated. Should a battery or charging system warning light illuminate, a mechanic should perform a few basic tests to determine if a battery replacement is needed.
Electrical components don’t work. Once a battery has started to fail, and the voltage produced by the battery drops, then vehicle electrical components can malfunction, such as the security system. If you are experiencing electrical malfunctions, it’s a smart idea to have the battery tested.

How do mechanics replace the battery?

A temporary power source might be installed to avoid the possibility of losing radio presets or stored data in the PCM while the battery is out. When the battery is already completely dead, this step is unnecessary.
The vehicle’s negative cable is removed from the battery, followed by the positive cable. The battery tie down system is loosened and the old battery removed.
Cable ends and wiring are carefully inspected to ensure cleanliness and no corrosion. In some cases, corrosion can be extreme and the cable may need to be replaced or wiring repaired.
The new battery is installed and the tie down system is reinstalled. Anti-corrosion compound is applied to the battery terminals. The positive terminal is reconnected followed by the negative terminal.
Some vehicles, for example some models of BMW, VW, and Audi, may require PCM programming to input battery parameters. This step, performed using a specialized scan tool, is necessary to maximize battery life and prevent electrical system malfunctions.
The car is started and charging system output is measured and compared against the factory OEM specification to ensure that the new battery will properly recharge. Generally, charging output will be in the range of 13.8 to 14.8 volts but the exact specifications vary by make and model.

Is it safe to drive with a battery problem?

Yes, but if you have a weak battery you might be left stranded somewhere if the battery dies completely and you cannot start your car. A faulty battery may also needlessly overload the alternator and could adversely affect the operation of the vehicle’s electrical system, including the vehicle security system and the shift interlock.

When replacing the battery keep in mind:

The quality of the electrical connections to the battery posts is important. Connections must be clean, free of corrosion and properly tightened.
Batteries store a large amount of energy and if short-circuited a battery could explode and can create intense discharges that can damage your eyesight. Insulated tools should be used to attach cabling to battery terminals. Otherwise, the battery’s positive cable can be shorted to ground or the positive and negative posts can be directly shorted. Batteries can only be safely installed from a positive terminal to positive wiring and from a negative terminal to body ground. If the polarity is reversed damage will likely occur to the vehicle’s electrical system.
Generally, a car battery will have a service life of 4 to 7 years. If a load test on a battery reveals a significant reduction in the capacity of the battery to provide power, you should buy a new battery rather than wait for the old battery to fail completely.
Batteries should only be disconnected if the engine is off and the alternator is not running. Disconnecting a car battery while the alternator is running can cause a voltage spike that will damage sensitive electronic components in the vehicle, such as the PCM.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Jeep mechanics

Real customer reviews from Jeep owners like you.

Excellent Rating

(342)

Rating Summary

332

7

1

0

2

332

7

1

0

2

SEE REVIEWS NEAR ME

Ben

42 years of experience

1589 reviews

Ben

42 years of experience

by Ryan

Jeep Wagoneer L6-4.0L - Automatic Transmission Fluid Service - Houston, Texas

Ben did a fantastic job!

Jeff

34 years of experience

441 reviews

Jeff

34 years of experience

by ebony

Jeep Wagoneer L6-4.0L - Starter - Davis, California

Jeff was fantastic I was sceptic all about using this service and he made it amazing did a great job in a timely manner really can't say enough good things about this experience!

John

28 years of experience

72 reviews

John

28 years of experience

by Richard

Jeep Grand Cherokee V6-3.6L - Battery - Jupiter, Florida

John was able to quickly diagnose the problem and fixed it on the spot. He was professional and courteous throughout the appointment and will definitely be my first call if I need mobile assistance again.

Robert

23 years of experience

343 reviews

Robert

23 years of experience

by Larry

Jeep Commander V8-5.7L - Battery - Coppell, Texas

He was on time, wore a mask, friendly, he did the work quickly, did it correctly.

Excellent Rating

(342)

Rating Summary

332

7

1

0

2

332

7

1

0

2

SEE REVIEWS NEAR ME

Recent articles & questions

Symptoms of a Bad or Failing Ignition Trigger

If your car is hard to start, not starting at all, or its Check Engine Light comes on, you may need to replace the ignition trigger.

The Best Used Cars to Buy If You’re an Electrician

As As an electrician, you have to haul around wiring, tools and equipment, and tons of supplies. You can’t get by with a small used car, or even a big one. What you probably need is a good used cargo...

P0764 OBD-II Trouble Code: Shift Solenoid C Intermittent

P0764 means a faulty shift solenoid and irregular voltage readings; caused by a failed shift solenoid, internal ATF blockages

Coolant light keeps coming on. 2009 BMW 335 xDrive

Hello. It sounds like there may be a coolant leak somewhere that is hard to find. It would be a good idea to have the coolant system pressurized and inspected for leaks. By adding pressure to the coolant system, it...

Engine won't run - 2012 Buick Lacrosse

Hi there. Having to use a breaker bar, to free the engine from being locked-up, does not sound promising. Removing the serpentine belt, would eliminate an accessory component (ie; seized alternator) that may be preventing the engine from turning over....

Is the felt seal in a dodge 318 timing cover set needed?

The felt seal would be used inside the front timing cover in front of the seal as an addition to reduce the amount of seal leakage when the engine is not running and to help keep out excess dirt for...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com