GMC Envoy Engine is misfiring Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(314)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(314)

Engine is misfiring Inspection Service

How much does a Engine is misfiring Inspection cost?

On average, the cost for a GMC Envoy Engine is misfiring Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2009 GMC EnvoyL6-4.2LService typeEngine is misfiring InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2008 GMC EnvoyL6-4.2LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2005 GMC EnvoyL6-4.2LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2009 GMC EnvoyV8-5.3LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
2002 GMC EnvoyL6-4.2LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2007 GMC EnvoyL6-4.2LService typeEngine is misfiring InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
2008 GMC EnvoyV8-5.3LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
2003 GMC EnvoyL6-4.2LService typeEngine is misfiring InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example GMC Envoy Engine is misfiring Inspection prices

When an engines misfires, it’s usually readily apparent to the driver from the stuttering and jerking produced by the engine when one or more cylinders fails to fire properly, either because of ignition- or fuel-related issues. It is accompanied by a loss of power in direct proportion to the severity of the misfire.

It can be tricky for to track down the problem if the misfire only occurs under certain circumstances, for example, under load. Not all misfires occur across the operating spectrum.

For older vehicles:

On older, carbureted vehicles, the culprit will almost certainly be in the ignition system as older vehicles lack many of the sophisticated sensors that can cause a misfire. A vacuum leak or a faulty fuel pump can also cause this symptom as well. The first thing the mechanic will do is determine which cylinder or cylinders is misfiring, and the spark plug color is probably the best way to tell. The guilty plug will most likely be grayer than the others, which should tend toward brown coloring. If needed, the spark plug can be replaced.

The next step would be checking the wiring to that plug for cracks and deterioration, and replace as necessary.

For most modern vehicles:

In modern cars, misfiring will invariably be accompanied by a Check Engine light. In fact, checking for efficient combustion was the primary reason the U.S. government introduced the rules for OBD-II (on-board diagnostics, second generation). It was part of the push toward cleaner exhaust emissions.

A code reader will tell you which cylinder is to blame, but it may not say whether it is a problem relating to the injector serving that cylinder or the systems delivering the ignition spark. As with older vehicles, a look at the wires and spark plugs is a good idea. Checking them in the dark will sometimes reveal errant spark tracking, as will spraying them with a fine water mist.

One way mechanics check which spark plug is failing to hold its own is by running the engine at an idle speed high enough to produce the misfire, then removing leads from the coilpack (the unit that looks like the distributor we are used to seeing in older vehicles ) one by one. Most removals will cause a profound change in idling performance, but a defective wire will not. That will suggest that it’s either the spark plug or the coil serving that cylinder at fault. If a new spark plug at that cylinder does not remove the stumble, the mechanic may need to replace the coil pack or the wires as a set.

If it isn’t an ignition issue, then the injectors will need to be checked. A mechanic uses a multimeter to check the resistance value at each injector. It may be a bit difficult to reach them, sometimes requiring the removal of an engine cover and the intake manifold. The mechanic disconnects the injector, then touches the multimeter probes to the two connector prongs to read the value, in Ohms. If any of the injectors read outside of the specified values, they will need to be replaced.

Along the same lines, a fuel pump starting to go bad can also cause misfires or similar issues and can be diagnosed with a fuel pressure check of the entire system with the appropriate equipment. This should only be done by a qualified mechanic as the fuel system is highly pressurized and of course, fuel is flammable.

Common reasons for this to happen:

  • Faulty spark plugs or wires
  • Faulty ignition coil
  • Broken piston rings
  • Burnt or bent valves
  • Broken valve springs
  • Camshaft worn out
  • Fuel injector is not working

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the source and cause of the misfiring engine, and will then provide a detailed inspection report that includes the scope and cost of the necessary repairs.

How important is this service?

A misfiring engine is accompanied by a loss of power, which makes this issue a critical one to correct promptly. Book a mechanic to perform a thorough inspection as soon as possible.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert GMC mechanics

Real customer reviews from GMC owners like you.

Excellent Rating

(314)

Rating Summary
293
11
2
0
8
293
11
2
0
8

David

28 years of experience
142 reviews
David
28 years of experience
GMC Envoy V8-5.3L - Engine is misfiring - San Diego, California
always does a great job

Nathan

29 years of experience
260 reviews
Nathan
29 years of experience
GMC Envoy L6-4.2L - Engine is misfiring - Tulsa, Oklahoma
Did well. Will be scheduling him again when needed

Robert

37 years of experience
237 reviews
Robert
37 years of experience
GMC Envoy V8-5.3L - Engine is misfiring - Powder Springs, Georgia
I am very particular about who works on my vehicle. I feel that Robert knows what he is doing and I would not hesitate to suggest him to others.

Joseph

24 years of experience
44 reviews
Joseph
24 years of experience
GMC Envoy L6-4.2L - Serpentine/Drive Belt - Laveen, Arizona

Excellent Rating

(314)

Rating Summary
293
11
2
0
8
293
11
2
0
8
Number of GMC Envoy services completed
3454+
services done by our mechanics
TOTAL NUMBER OF EXPERT GMC MECHANICS
900+
experts on our platform

Recent articles & questions

Rules of the Road For Florida Drivers
Many Many of the laws for driving are based on common sense, which means they are often the same from one state to the next. However, while you may be familiar with the laws in your own state, other states...
Understanding Land Rover Service Indicator Lights
Car symbols, or dashboard lights, are a car service reminder. The Land Rover mileage-based system indicates when and what service your car needs.
P0834 OBD-II Trouble Code: Clutch Pedal Switch “B” Circuit Low
P0834 means there is an issue with the clutch position sensor circuit, usually due to a faulty sensor or damaged electrical components.

Headlights go out randomly, will come back on after

As silly as it sounds, the issue is most likely caused by an intermittent failure in your Totally Integrated Power Module (TIPM). Of course it’s important to have the circuit and connections checked, but the TIPM is the most common...

Overheating at the traffic light or while AC is on

You may have a restriction in your radiator or condenser that is preventing the cooling of the respective fluids that go through these parts. Restrictions will cause hot spots and therefore will not allow sufficient cooling of the refrigerant or...

I cannot move my car in reverse when on a hill, nothing happens when I press the gas pedal

The Nissan Rogue is equipped with a Continuously Variable Transmission. They are known to experience issues such as not moving in any gear when the gas pedal is applied, even floored. It may be slipping due to internal issues with...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com