GMC Acadia Power Steering Pump Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a GMC Acadia Power Steering Pump Replacement is $1047 with $263 for parts and $784 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2015 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1413.62	Shop/Dealer Price$1570.19 - $1994.52
2012 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1344.46	Shop/Dealer Price$1486.46 - $1889.35
2011 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1344.46	Shop/Dealer Price$1486.61 - $1889.60
2009 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1344.46	Shop/Dealer Price$1486.60 - $1889.59
2010 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1344.46	Shop/Dealer Price$1494.85 - $1904.03
2013 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1344.46	Shop/Dealer Price$1487.39 - $1890.97
2008 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1344.46	Shop/Dealer Price$1486.69 - $1889.75
2007 GMC AcadiaV6-3.6L	Service typePower Steering Pump Replacement	Estimate$1344.46	Shop/Dealer Price$1486.60 - $1889.59

Show example GMC Acadia Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
The threaded connectors to the pump inlet and outlet are loosened and removed.
Any mounting bolts and brackets are removed so the pump can be removed.
If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert GMC mechanics

Real customer reviews from GMC owners like you.

Excellent Rating

(3)

Rating Summary

3

0

0

0

0

3

0

0

0

0

SEE REVIEWS NEAR ME

Excellent Rating

(3)

Rating Summary

3

0

0

0

0

3

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

Top Automotive News & Stories: July 27-August 3

Each week we compile the best announcements and developments from the world of cars. Here are the topics you can’t miss from July 27 to August 3. Most Stolen Cars List Released most stolen cars...

How to Replace an Air Injection Pump Filter

Air pump filters may be failing when the engine has a rough idle and is sluggish. Reduced fuel economy may also indicate a bad filter.

All About Car Service Indicator Lights

No matter which manufacturer your car is from, there is a service indicator light that lets you know when your car needs maintenance or attention.

Replacing transmission on '95 Toyota Corolla with Celica transmission

You shouldn't just be swapping those things because it's a different engine, different size, and different gear ratio in them. Just live with whatever it does because you really shouldn't be doing these types of swap. I know guys who...

My battery light came on out of nowhere and I started smelling smoke.

This may suggest a failing voltage regulator. The voltage regulator is a unit that regulates the charging of the battery (https://www.yourmechanic.com/services/battery-will-not-hold-a-charge-inspection) by the alternator. When the voltage regulator is not working properly, this may result in the alternator allowing too...

Will a 2002 transmission fit into a 2007

Hello there, a transmission from a 2000 Nissan Xterra will not fit into your 2007 Nissan Xterra. The automatic transmission from the 2000 model is a 4 speed unit, where as the 2007 is a 5 speed transmission that is...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com