Ford Ranger Power Steering Pump Replacement at your home or office.

Our mobile mechanics offer services 7 days a week. Upfront and transparent pricing.

Estimate price near me

Service Location

Customer Ratings

(12)

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

Customer Ratings

(12)

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Ford Ranger Power Steering Pump Replacement is $269 with $87 for parts and $182 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1992 Ford RangerV6-4.0LService typePower Steering Pump ReplacementEstimate$477.58Shop/Dealer Price$544.25 - $732.11
2000 Ford RangerV6-4.0LService typePower Steering Pump ReplacementEstimate$421.71Shop/Dealer Price$482.07 - $657.80
2004 Ford RangerL4-2.3LService typePower Steering Pump ReplacementEstimate$450.95Shop/Dealer Price$518.65 - $716.34
1990 Ford RangerV6-4.0LService typePower Steering Pump ReplacementEstimate$493.26Shop/Dealer Price$557.69 - $743.87
2001 Ford RangerV6-4.0LService typePower Steering Pump ReplacementEstimate$431.67Shop/Dealer Price$496.47 - $681.13
1999 Ford RangerElectricService typePower Steering Pump ReplacementEstimate$421.71Shop/Dealer Price$482.28 - $658.17
2001 Ford RangerL4-2.5LService typePower Steering Pump ReplacementEstimate$450.95Shop/Dealer Price$518.67 - $716.37
1999 Ford RangerV6-4.0LService typePower Steering Pump ReplacementEstimate$421.71Shop/Dealer Price$482.10 - $657.85
Show example Ford Ranger Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

  • Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
  • Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
  • Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
  • Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

  • If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
  • If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
  • The threaded connectors to the pump inlet and outlet are loosened and removed.
  • Any mounting bolts and brackets are removed so the pump can be removed.
  • If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
  • The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
  • Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

  • Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
  • Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Ford mechanics

Real customer reviews from Ford owners like you.

Excellent Rating

(12)

Rating Summary
12
0
0
0
0
12
0
0
0
0

Rafael

25 years of experience
65 reviews
Rafael
25 years of experience
Ranger 1993 - Power Steering Pump - El Cerrito, CA
Wonderful service! Thank you, Rafael!

Todd

10 years of experience
48 reviews
Todd
10 years of experience
Ranger 1989 - Power Steering Pump - Portland, OR
Excellent thorough job.

Jesse

15 years of experience
14 reviews
Jesse
15 years of experience
Ranger 2000 - Spark Plugs - Daytona Beach, FL
Jesse was on time. And did a great job.

Jesse

15 years of experience
14 reviews
Jesse
15 years of experience
Ranger 2000 - Car is not starting - Daytona Beach, FL
Jesse is a very knowledgeable, courteous mechanic. He is definately trustworthy and competent.

Excellent Rating

(12)

Rating Summary
12
0
0
0
0
12
0
0
0
0
Number of Ford Ranger Power Steering Pump Replacement services completed
132+
services done by our mechanics
TOTAL NUMBER OF EXPERT Ford MECHANICS
1800+
experts on our platform

Recent articles & questions

A Buyer’s Guide to the 2012 Audi R8
The The 2012 Audi R8 is a two-door sports car with plenty of power and performance to offer. It manages to combine an aggressive stance and plenty of get-up-and-go with the comfort and interior refinement you’d expect from a German...
Symptoms of a Bad or Failing Air Filter
Check if your car's air filter is dirty. If you notice a decrease in gas mileage or engine performance, you may have to replace your air filter.
How to Renew Your Car Registration in North Carolina
Moving Moving to North Carolina can be a great experience. When first moving to the state, you will need to make sure that your car is registered with the North Carolina Department of Motor Vehicles(DMV). This will allow you to...

Cars tries to crank, but will not start.

If your battery is good that leaves you with 2 likely options. There could be a problem with the connections to the starter from the battery. It's possible that a connection is either loose or badly corroded which will not...

Whistling noise when braking and accelerating

Hello. If the noise occurs when applying the brakes and not moving then you may have a failure in the brake assist. If it only occurs when the vehicle is moving then you may have a failure in one of...

Losing antifreeze

Hi there. You could be losing antifreeze in either the combustion cylinders or the engine valley. Inspect the spark plugs for signs of antifreeze entering the cylinder. If there is an intake manifold leak or any other leak that could...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com