Ford Explorer Power Steering Pump Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Ford Explorer Power Steering Pump Replacement is $298 with $116 for parts and $182 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
1995 Ford ExplorerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$464.42	Shop/Dealer Price$527.80 - $705.79
2010 Ford ExplorerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$555.51	Shop/Dealer Price$645.85 - $911.12
2008 Ford ExplorerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$555.51	Shop/Dealer Price$645.89 - $911.18
2005 Ford ExplorerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$446.27	Shop/Dealer Price$509.34 - $692.70
2000 Ford ExplorerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$450.91	Shop/Dealer Price$513.88 - $691.57
1999 Ford ExplorerV8-5.0L	Service typePower Steering Pump Replacement	Estimate$434.83	Shop/Dealer Price$498.68 - $684.41
1999 Ford ExplorerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$450.91	Shop/Dealer Price$511.70 - $687.74
1998 Ford ExplorerV6-4.0L	Service typePower Steering Pump Replacement	Estimate$450.91	Shop/Dealer Price$511.67 - $687.70

Show example Ford Explorer Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
The threaded connectors to the pump inlet and outlet are loosened and removed.
Any mounting bolts and brackets are removed so the pump can be removed.
If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Ford mechanics

Real customer reviews from Ford owners like you.

Excellent Rating

(10)

Rating Summary

10

0

0

0

0

10

0

0

0

0

SEE REVIEWS NEAR ME

Excellent Rating

(10)

Rating Summary

10

0

0

0

0

10

0

0

0

0

SEE REVIEWS NEAR ME

Recent articles & questions

How Long Should It Take a Heater to Warm Up in Cold Weather

When When you turn on your car’s heater, it should start blowing warm air. If the engine is already at operating temperature, this should happen immediately. However, if your engine is cold, it will take longer and if the weather...

Veteran and Military Driver Laws and Benefits in Alabama

The The state of Alabama offers a number of benefits and perks for those Americans who have either served in an Armed Forces branch in the past, or are current active military members. License and registration tax and fee exemption...

How Much Does a Mechanic Make in North Carolina?

Automotive technician jobs in North Carolina have an average mechanic salary of $40k, while the national average is roughly $37k.

Turbo oil leak - air filter intake

Hi there: Although we don't see may of these vehicles here in the United States, on your 20102 Chevrolet Captiva Sport and most four-cylinder turbocharged vehicles; there are multiple oil seals that can wear out on the turbo, the fuel...

Car wont start or turn over. battery is working fine and all electronics work. starter is working too. just not with the key

It sounds like what you are describing may be related to a faulty starter relay or some faulty wiring that may not be producing a proper connection to the starter. The starter relay (https://www.yourmechanic.com/services/starter-relay-replacement) directs power from the battery to...

Are [spark plugs](/topics-spark-plug-nissan/) interchangeable from one vehicle to another for example from a 2015 Nissan to a 1995 eagle talon?

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com