Dodge Dakota Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(496)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(496)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Dodge Dakota Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
2008 Dodge DakotaV8-4.7LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
2001 Dodge DakotaL4-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1989 Dodge DakotaV6-3.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1999 Dodge DakotaV8-5.9LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1991 Dodge DakotaL4-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
2004 Dodge DakotaV8-4.7LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1995 Dodge DakotaV6-3.9LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1997 Dodge DakotaV8-5.2LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Dodge Dakota Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Dodge mechanics

Real customer reviews from Dodge owners like you.

Excellent Rating

(496)

Rating Summary
459
23
4
3
7
459
23
4
3
7

Lee

38 years of experience
217 reviews
Lee
38 years of experience
Dodge Dakota V6-3.9L - Car starts and then dies - Oklahoma City, Oklahoma
Lee was very thorough and performed the complete inspection and hopefully identified the problem.

Casey

24 years of experience
152 reviews
Casey
24 years of experience
Dodge Dakota V8-5.2L - Car starts and then dies - Seattle, Washington
great, earlier than expected

Brian

24 years of experience
200 reviews
Brian
24 years of experience
Dodge Dakota V8-4.7L - Car starts and then dies - Frederick, Maryland
On time quick worker

Jimmi

27 years of experience
231 reviews
Jimmi
27 years of experience
Dodge Dakota V8-4.7L - Ball Joint Front Replacement (Lower Left, Lower Right) - Sanford, Florida
Smooth repair throughout....definite A+

Excellent Rating

(496)

Rating Summary
459
23
4
3
7
459
23
4
3
7
Number of Dodge Dakota services completed
5456+
services done by our mechanics
TOTAL NUMBER OF EXPERT Dodge MECHANICS
1400+
experts on our platform

Recent articles & questions

How to Buy a Good Quality Brake Hose
Brake Brake hoses, sometimes used interchangeably with the term “brake lines,” carry brake fluid between the master cylinder and the wheel cylinder or brake calipers - depending upon the type of brakes you have. The pressure from the brake fluid...
How Long Does a Clutch Switch Last?
The The clutch switch, also known as a clutch sensor, is a safety device on most modern manual transmission vehicles. Its purpose is to prevent the engine from starting while the vehicle is in gear. The switch is normally mounted...
How to Diagnose Blown Car Speakers
Even Even the highest-quality audio systems wear out over time, especially if you like to listen to your music at a high volume. If your car’s speakers (https://www.yourmechanic.com/article/4-essential-things-to-know-about-your-car-s-stereo-and-speakers) seem muted or if they are not working at all, you need...

After tire rotation thumping noise developed - 2006 Chevrolet Avalanche 2500 Automatic

The "thumping" sound you mention seems more like the torque convertor lock-up clutch in the transmission failing. It tries to lock up, can't recycles, etc. GM has a service bulletin on this problem - TSB Reference #3438A. Discuss this with...

Dashboard lights not working

Hello. There are a couple of things that come to mind. The wire that is not connected to anything could be the wire that is causing the problem. That wire could be shorting the turn signal system once it is...

Do I need brakes or rotors? I was told I needed rotors and a wheel alignment

This may be a sign of warped brake rotors (https://www.yourmechanic.com/services/brake-rotor-disc-replacement). As you may know, when you press on your brake pedal, this activates a hydraulic pressure which forces small pistons inside your brake calipers (https://www.yourmechanic.com/services/brake-caliper-replacement) to push the brake pads...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com