Chevrolet S10 Car is hard to start Inspection at your home or office.

Common reasons for this to happen:

• Bad Starter: Over time starter motors can wear out and start to malfunction. If this is the problem the starter will have to be replaced. If the car turns over, the problem is not the starter. If nothing happens when the key is turned the problem could be the starter, or if the car turns over very slowly and the dash lights dim while it is cranking, the starter could be the culprit.

• Bad Relay Wiring: The wiring between the battery and starter can become loose or broken which will prevent the starter motor from functioning. The wiring will need to be replaced or repaired.

• Low or Dead Battery: The starter motor needs voltage from the battery to operate. If the battery is low or failing it may not produce enough current for the starter motor to function. Charging or replacing the batter should resolve this problem.

It is also possible that the battery terminals have become corroded or loose. Cleaning and tightening the terminals and cables is recommended.

• Failing Solenoid: A failing solenoid is a common issue with the starter system and if the solenoid is going bad, the car will be difficult to start. The starter will need to be inspected to determine if the problem is the starter motor itself or the solenoid. A failing solenoid will need to be replaced.

• Failing Ignition Switch: Over time an ignition switch can start to fail and one of the most common symptoms is that the car is hard to start. If the ignition switch is hot to the touch this indicates an issue with the ignition switch wiring. A failing ignition switch will eventually stop working completely and will need to be replaced.

• Defective Fuel Pump: If the engine is not getting enough fuel, it will be hard, if not impossible to start. The fuel pump is responsible for pulling gas from the tank to the injectors and if it is not delivering enough fuel the car will be difficult to start and eventually will not start at all.

• Fouled Plugs: Spark plugs create the spark which allows the vehicle to burn fuel. Fouled plugs are one of the most common reasons for a hard starting engine. As electrodes wear down, the voltage required to jump the gap to ignite the fuel increases. This can lead to prolonged cranking before the engine will start.

• Clogged Fuel Filter: A fuel filter that is clogged can make a vehicle very difficult to start. The fuel filter screens out contaminants and can become clogged over time. This will prevent the injectors from getting enough fuel, making the car hard to start.

• Contaminated Fuel: Fuel that has too much alcohol or water in it will result in a car that is difficult and often impossible to start. Even if it does start, contaminated fuel can do serious damage to the engine. If contaminated fuel is suspected, have the vehicle inspected immediately.