Chevrolet Monte Carlo Power Steering Pump Replacement Costs

Estimate price near me

Service Location

Customer Ratings

Included for free with this service

Online Booking

Mechanic comes to you

12-month / 12k-mile warranty

Free 50 point safety inspection

Our certified mobile mechanics can come to your home or office 7 days a week between 7 AM and 9 PM.

See availability

Customer Ratings

Power Steering Pump Replacement Service

How much does a Power Steering Pump Replacement cost?

On average, the cost for a Chevrolet Monte Carlo Power Steering Pump Replacement is $244 with $104 for parts and $140 for labor. Prices may vary depending on your location.

Car	Service	Estimate	Shop/Dealer Price
2001 Chevrolet Monte CarloV6-3.8L	Service typePower Steering Pump Replacement	Estimate$550.12	Shop/Dealer Price$624.38 - $832.58
2006 Chevrolet Monte CarloV6-3.5L	Service typePower Steering Pump Replacement	Estimate$534.51	Shop/Dealer Price$623.07 - $883.40
2005 Chevrolet Monte CarloV6-3.4L	Service typePower Steering Pump Replacement	Estimate$426.45	Shop/Dealer Price$498.42 - $710.16
2005 Chevrolet Monte CarloV6-3.8L Turbo	Service typePower Steering Pump Replacement	Estimate$460.91	Shop/Dealer Price$531.10 - $736.25
1998 Chevrolet Monte CarloV6-3.1L	Service typePower Steering Pump Replacement	Estimate$379.91	Shop/Dealer Price$438.40 - $605.64
2003 Chevrolet Monte CarloV6-3.4L	Service typePower Steering Pump Replacement	Estimate$365.31	Shop/Dealer Price$422.14 - $588.13
2002 Chevrolet Monte CarloV6-3.4L	Service typePower Steering Pump Replacement	Estimate$365.31	Shop/Dealer Price$422.01 - $587.91
2000 Chevrolet Monte CarloV6-3.4L	Service typePower Steering Pump Replacement	Estimate$379.91	Shop/Dealer Price$436.78 - $602.80

Show example Chevrolet Monte Carlo Power Steering Pump Replacement prices

What is the power steering pump and how does it work?

The power steering pump is a belt-driven or electric-driven hydraulic pump that generates the hydraulic pressure needed to provide power steering assist. It develops output pressures of 1,000 PSI or more. The pump output is directed to the steering gear, often a rack and pinion type unit, where the hydraulic pressure pushes on the steering rack, greatly reducing the effort it would otherwise take to turn the steering wheel.

Power Steering

When to consider replacing the power steering pump:

Groaning or whining noise when turning. Noise can occur if there is wear on the pump bearings or impeller vanes. A low fluid level or trapped air can also cause noises. If the pump has already been operating while dry, adding fluid may not resolve the noise and replacement of the pump might be necessary.
Power steering fluid leaks. Leaks can develop at pump seals, threaded connections, hoses, or on the steering rack and pinion unit. Pump seal leaks will generally require a replacement.
Difficult steering. Should you notice it is harder to turn the steering wheel, it might mean the power steering pump output pressure is too low, or there could be blockages in the pump or lines.
Damage to the pump pulley. Should the pump pulley become damaged or is loose on the pump shaft, you might detect vibration, drive belt damage, or hard steering. Either the pulley will have to be serviced or the pump assembly replaced.

How do mechanics replace the power steering pump?

If driven by a drive belt, the power steering pump is bolted to the engine via a bracket that allows for adjustment of the pump drive belt. Once the engine is cold, and safe to work on, the drive belt is removed.
If driven by an electric pump, the pump may be mounted in conjunction with the steering shaft or in conjunction with the steering rack. With either a drive belt or electric pump, removal of any dash, panel, or steering components is performed to access the pump.
The threaded connectors to the pump inlet and outlet are loosened and removed.
Any mounting bolts and brackets are removed so the pump can be removed.
If the old pump has failed catastrophically, or there is reason to suspect contaminants in the power steering hoses, the system is flushed.
The new pump is bolted on, the pressure and return hoses attached and the system is bled of all air. If pump is belt-driven, it is tightened to the manufacturer’s specification.
Finally, the engine is run and the car is road tested to confirm normal steering effort. If a new drive belt was installed, belt tension is measured again, and adjusted as needed, after the belt has run for a few minutes.

Is it safe to drive with a power steering pump problem?

No. If the power steering pump is operated without an adequate amount of fluid, and the pump reservoir will not hold fluid due to a large leak. The pump could seize, which would snap the serpentine belt and likely leave you stranded. If the pump turns and there is adequate fluid, but there is no power assist, it will require much greater effort to turn the steering wheel, and that presents inherent safety risks. Generally, the wisest course is to seek immediate repairs if you suspect a problem with any component in your car’s power steering system.

When replacing the power steering pump keep in mind:

Any belts driving the pump should be inspected and replaced as needed. The pump will only produce the required hydraulic pressure if it is driven by the belt at an adequate speed.
Power steering leaks from aged rubber hoses, particularly where the rubber is crimped to the steel tube, are not unusual and should be carefully inspected. The system operates under high pressure. The fluid is flammable, and if leaking fluid happens to contact a hot engine part, a fire might result. You always want to be sure the hoses and connections are sound.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee

Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(242)

Rating Summary

218

9

2

0

13

218

9

2

0

13

SEE REVIEWS NEAR ME

Marko

5 years of experience

21 reviews

Marko

5 years of experience

by Ruben Escalante

Monte Carlo 1999 - Brake Pads - San Diego, CA

Professional, Friendly, Honest, knowledgeable. Greatly appreciate his advice and the job he did.

Adam

16 years of experience

142 reviews

Adam

16 years of experience

by Michael Goldman

Monte Carlo 2004 - Power Steering Pump - Boynton Beach, FL

Amazing service, really cares about his work!

Leo

17 years of experience

80 reviews

Leo

17 years of experience

by Davindra Baboolall

Monte Carlo 2007 - Car is not starting - Greensboro, NC

He did an checked everything possible he was a really good guy did his best even checked the cam.

Patrick

26 years of experience

1550 reviews

Request Patrick

Patrick

26 years of experience

Request Patrick

by Jimmy Diaz

Monte Carlo 1985 - Transmission Fluid Service - Austin, TX

Again great service friendly professional knowledgeable it’s persons like Patrick that makes a great team. I will definitely recommend him to friends and family members.

Excellent Rating

(242)

Rating Summary

218

9

2

0

13

218

9

2

0

13

SEE REVIEWS NEAR ME

Recent articles & questions

Is it Safe to Drive With a Stuck Caliper?

The caliper is part of the brake assembly which houses the brake pads and pistons. If you have a stuck caliper, the...

How to Break in Brake Pads

Having new brake pads and rotors installed happens on a regular basis. Once those brake pads and rotors are mounted, it is...

How to Transfer a Car Title in Texas

Whenever Whenever there is a change of vehicle ownership in Texas, the title must be transferred from the previous owner’s name to that of the current owner. This applies to the buying and selling process, but also to giving a...

Can no longer accelerate

This concern could be caused by a number of problems. It could be related to the Electronic Stability Control (ESC) system or the throttle-by-wire system. If there are no lights illuminating on the dash, it may be tricky to diagnose...

AC fan only works on high

This is a common problem when the A/C blower motor resistor goes out. This is an inexpensive part to replace and is found under the dash near the A/C blower motor. This resistor controls the speed of the blower fan....

My car is slow to accelerate, and it stalls in drive and reverse

This may be related to a dirty or failing idle air control valve (https://www.yourmechanic.com/services/idle-control-valve-replacement). The idle air control valve monitors the air intake as it is mixed with fuel prior to being injected into the engine at low speeds and...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com