Chevrolet Lumina Car starts and then dies Inspection at your home or office.

Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM.

Estimate price near me

Service Location

Customer Ratings

(75)

How A Diagnostic Works

Instantly book a certified mobile mechanic to come to you

Mechanic diagnoses the problem and quotes necessary repairs

Your vehicle is ready to go

Fair, upfront & transparent pricing for all services

Our certified mobile mechanics can come to you now.

Customer Ratings

(75)

Car starts and then dies Inspection Service

How much does a Car starts and then dies Inspection cost?

On average, the cost for a Chevrolet Lumina Car starts and then dies Inspection is $95 with $0 for parts and $95 for labor. Prices may vary depending on your location.

CarServiceEstimateShop/Dealer Price
1991 Chevrolet LuminaL4-2.5LService typeCar starts and then dies InspectionEstimate$114.99Shop/Dealer Price$124.99 - $132.49
1992 Chevrolet LuminaV6-3.1LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1990 Chevrolet LuminaL4-2.5LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1995 Chevrolet LuminaV6-3.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$104.99 - $112.48
1998 Chevrolet LuminaV6-3.8LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.02 - $112.55
1996 Chevrolet LuminaV6-3.4LService typeCar starts and then dies InspectionEstimate$94.99Shop/Dealer Price$105.01 - $112.52
1997 Chevrolet LuminaV6-3.4LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$109.87 - $117.28
1990 Chevrolet LuminaV6-3.1LService typeCar starts and then dies InspectionEstimate$99.99Shop/Dealer Price$110.24 - $117.94
Show example Chevrolet Lumina Car starts and then dies Inspection prices

Starting a vehicle only to have it quit immediately after can be confusing and annoying for many drivers especially if their vehicle has not experienced this type of issue before. Typically, a vehicle will start and then quit because of an issue with the fuel or electrical system. It is important to monitor fuel levels as well as warning lights which can signal to the driver that a vehicle may quit unexpectedly.

How this system works:

To start a vehicle, the electrical system, composed of the battery and starter, turns the engine over. Once running, the engine requires a constant flow of gasoline and good spark to keep that fuel igniting. If gasoline is not readily available, or if there is not enough spark, the engine will quit. More modern vehicles with sophisticated computers may affect the way the vehicle runs. These computers help the car run efficiently but can also shut a car down if the fuel/air mixture is not correct. While an older vehicle may be less sophisticated and easier to diagnose, the computers on modern cars can provide more specific information when connected to a code scanner/reader.

Common reasons for this to happen:

  • Mass Airflow Sensor: The mass airflow sensor measures how much air is entering the engine and relays this information to the vehicle’s computer so that the right amount of fuel can be delivered from the fuel injectors. When a sensor begins to fail, the vehicle’s computer may generate an error code to indicate that something has gone wrong. An issue with the mass airflow sensor may manifest itself when a car starts and then stalls soon after starting.

  • Fuel Pump Relay: The fuel pump relay functions much like a fuse for an electric fuel pump. The fuel pump relay engages as the vehicle is started and starts the fuel pump. While the vehicle is running, the fuel pump relay turns off and the fuel pump is powered by the oil pressure sending unit. If the vehicle’s computer is unable to keep the fuel pump relay running throughout the starting process, the vehicle may start and quit immediately after starting.

  • Ignition Coil: Your vehicle’s ignition coil takes the low voltage of the battery and provides the thousands of volts needed to create a spark in the spark plugs. When an ignition coil begins to fail, it may struggle to provide consistent spark to the plugs, causing the engine to stall after starting.

What to expect:

A top-rated mobile mechanic will come to your home or office to determine the reason why the vehicle starts and then dies. The mechanic will then provide a detailed inspection report outlining why the vehicle quit and the cost of any repairs that need to be made.

How it's done:

A mechanic will begin diagnosing your vehicle’s issue by plugging a code reader/scanner into the vehicle’s computer. The mechanic should be able to get more information from your vehicle’s computer on what component has failed. Using this information, the mechanic can begin necessary repairs.

If your vehicle has a bad or failing mass airflow sensor, the mechanic will begin by finding the sensor in the engine bay and checking for any signs of failure. The mechanic should check the wire harness connected to the sensor to ensure that all of wires are properly connected. After removing the sensor, the mechanic should be able to discover the nature of the failure and replace the sensor.

If the mechanic suspects an issue with the fuel pump relay, he or she should check the vehicle’s computer for a problem. If the vehicle’s computer is having difficulty providing consistent power to the fuel pump relay, the computer may need to be reprogrammed or replaced. If the vehicle’s computer is functioning normally, the mechanic may need to replace the fuel pump relay.

If the mechanic suspects that the ignition coil may be faulty, he or she should first disconnect the battery before beginning work. The mechanic should then begin the process of disconnecting wires from the ignition coil and removing it from the engine bay. The mechanic will then install the new ignition coil and ensure that it is connected properly. The mechanic should then reconnect the battery and test the new coil.

With all repairs, the mechanic will ensure the newly installed parts work properly. The mechanic can then turn off and warning lights that may have come on while the vehicle was not running properly.

How important is this service?

If your vehicle is starting but dying soon after starting, you should have it checked out by a mechanic. Issues involving the fuel management and electrical systems will become worse if not dealt with. Diligence and paying attention to warning lights may help prevent further damage to critical engine component and may save money in repairs. A vehicle that quits after starting can be inconvenient and having a mobile mechanic inspect and repair you vehicle will ensure that you and your vehicle are back on the road soon.

Fast and easy service at your home or office

Backed by 12-month, 12.000-mile guarantee


Meet some of our expert Chevrolet mechanics

Real customer reviews from Chevrolet owners like you.

Excellent Rating

(75)

Rating Summary
72
1
1
0
1
72
1
1
0
1

James

19 years of experience
96 reviews
James
19 years of experience
Chevrolet Lumina V6-3.1L - Window Motor Replacement (Driver Side Front) - Glendale, Arizona
James was right on time. He assessed the car and then right to work. Very professional, knowledgeable, and friendly on top of it all. Work was completed as agreed and we are very happy.

Brett

10 years of experience
197 reviews
Brett
10 years of experience
Chevrolet Lumina V6-3.1L - Crankshaft Harmonic Balancer - Buda, Texas
Great job, fast, and very professional. Would definitely call him again.

Rigoberto

11 years of experience
739 reviews
Rigoberto
11 years of experience
Chevrolet Lumina V6-3.1L - Car Horn Replacement - Skokie, Illinois
GREAT EXPERIENCE WITH RIGO!!! HIGHLY RECOMMEND!!!

Noe

36 years of experience
604 reviews
Noe
36 years of experience
Chevrolet Lumina V6-3.1L - Serpentine/Drive Belt - Seattle, Washington
He always does a great job I reccomend him to everyone. He is just awesome. He is honest and works quickly

Excellent Rating

(75)

Rating Summary
72
1
1
0
1
72
1
1
0
1
Number of Chevrolet Lumina services completed
825+
services done by our mechanics
TOTAL NUMBER OF EXPERT Chevrolet MECHANICS
1600+
experts on our platform

Recent articles & questions

Writing Off Your Business Miles: A Crash Course
Track the miles you drive for work to deduct the cost from your taxes. Use a mileage log to give an accurate number to the government.
P3441 OBD-II Trouble Code: Cylinder 6 Deactivation/Intake Valve Control Circuit/Open
P3441 means the PCM doesn’t receive the correct information from the MAF, MAP, and TP sensors due to clogged oil, low oil pressure, or shorts.
P2788 OBD-II Trouble Code: Auto Shift Manual Adaptive Learning at Limit
P2788 means an issue with the adaptive learning system of the transmission which causes stalling at idle, harsh shifting and transmission overheating.

How do I check the brake fluid?

Your car’s brakes are the most important safety system onboard. They’re hydraulic, which means they require fluid in order to operate. When you press the brake pedal, fluid is sent from the master cylinder through the brake lines to the...

Advice on RPM increase

RPM (https://www.yourmechanic.com/article/how-to-check-rpm-by-jason-unrau) just depends on your engine. I've had motorcycle engines that you can rev up to 16,000 RPMs and it didn't hurt anything. It depends on how they are designed and what they are set up for. Now, if...

Replaced ECU Integrated Transfer Case Board, how much will it cost to reprogram it?

Hey there, thanks for writing in about your 2006 Land Rover LR3. Unfortunately, this is a specialized service only available through Land Rover service centers, and not a cost estimate readily available to us here at YourMechanic. I recommend requesting...

How can we help?

Our service team is available 7 days a week, Monday - Friday from 6 AM to 5 PM PST, Saturday - Sunday 7 AM - 4 PM PST.

1 (844) 997-3624 · hi@yourmechanic.com